Abstract
A module for tool development (including design) is analyzed within the framework of the proposed design procedure for nonstationary production systems. Specifically, the tool considered is used for slipway machining of channels to be welded into submarine hulls.
Similar content being viewed by others
REFERENCES
Rusanovskii, S.A., Khudyakov, M.P., and Klimov, Yu.V., Design of production systems. 1. Development of the design procedure, Russ. Eng. Res., 2020, vol. 40, no. 10, pp. 815–818.
Rusanovskii, S.A. and Khudyakov, M.P., Design of production systems. Part 2. Nonstationary systems, Russ. Eng. Res., 2020, vol. 40, no. 11, pp. 901–904.
Spravochnik tekhnologa-mashinostroitelya (Handbook of Technologist-Machine Engineer), Dal’skii, A.M., Kosilova, A.G., Meshcheryakov, R.K., and Suslov, A.G., Eds., Moscow: Mashinostroenie, 2001, vol. 1.
Loktev, A.D., Gushchin, F., Balashov, B.N., et al., Obshchemashinostroitel’nye normativy rezhimov rezaniya. Spravochnik (General Machine Engineering Standards of Cutting Modes: Handbook), Moscow: Mashinostroenie, 1991, vol. 2.
Author information
Authors and Affiliations
Corresponding authors
Ethics declarations
The authors declare that they have no conflicts of interest.
Additional information
Translated by B. Gilbert
About this article
Cite this article
Rusanovskii, S.A., Khudyakov, M.P. Design of Production Systems. 3. Tool Design. Russ. Engin. Res. 41, 16–18 (2021). https://doi.org/10.3103/S1068798X21010196
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X21010196