Abstract
The stamping of eyelets in brackets by plastic deformation is analyzed. The eyelet geometry and the basic requirements on the stamping process are determined. The force required for deformation of the metal in final shaping is established.
Similar content being viewed by others
REFERENCES
Kalyakulin, S.Yu., Kuz’min, V.V., Mitin, E.V., and Sul’din, S.P., Informational relational models for calculating the cutting conditions in automatic control systems, Russ. Eng. Res., 2018, vol. 38, no. 12, pp. 1049–1052.
Kalyakulin, S.Yu., Kuz’min, V.V., Mitin, E.V., and Sul’din, S.P., Informational relational models for calculating the cutting conditions in automatic control systems, Stanki Instrum., 2018, no. 7, pp. 2–4.
Mitin, E.V., Sul’din, S.P., and Okunev, D.V., Formalization of automated base selection in the design of machining processes, Stanki Instrum., 2018, no. 5, pp. 17–20.
Kalyakulin, S.Yu., Kuz’min, V.V., Mitin, E.V., et al., Development of a mathematical model of a part based on graphic system models, Inzh. Tekhnol. Sist., 2019, vol. 29, no. 1, pp. 67–76.
Kalyakulin, S.Yu., Kuz’min, V.V., Mitin, E.V., et al., Designing the structure of technological processes based on synthesis, Vestn. Mordovsk. Univ., 2018, vol. 28, no. 1, pp. 77–84.
Mitin, E.V. and Sul’din, S.P., Hob strength in gear cutting, Russ. Eng. Res., 2018, vol. 38, no. 8, pp. 635–637.
Mitin, E.V., Sul’din, S.P., and Okunev, D.V., Formalization of automated base selection in the design of machining processes, Russ. Eng. Res., 2018, vol. 38, no. 11, pp. 886–888.
Author information
Authors and Affiliations
Corresponding authors
Additional information
Translated by B. Gilbert
About this article
Cite this article
Mitin, E.V., Sul’din, S.P. & Mitina, A.E. Stamping of Eyelets in Brackets by Plastic Deformation. Russ. Engin. Res. 40, 1065–1068 (2020). https://doi.org/10.3103/S1068798X20120102
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X20120102