Abstract
Design options for equipment used to hone high-precision holes in measuring equipment and fuel systems are outlined. The available equipment permits self-stabilization of the tool–workpiece system, with compensation of errors in their mutual position. The quality and precision of the holes are improved by flushing of the wear products from the machining zone.
Similar content being viewed by others
REFERENCES
Akmaev, O.K., Straightening hole axis in precision honing, Russ. Eng. Res., 2008, vol. 28, no. 2, pp. 185–187.
Akmaev, O.K., Tool design for precision honing, Trudy Mezhdunarodnoi nauchno-tekhnicheskoi konferentsii “Optimizatsiya i upravlenie protsessom rezaniya, mekhatronnye tanochnye sistemy” (Proc. Int. Sci.-Tech. Conf. “Optimization and Control of Cutting and Mechatronic Machine Systems”), Ufa: Bashkir. Gos. Univ., 2004, pp. 224–228.
Kulikov, S.I., Rizvanov, F.F., et al., Progressivnye metody khoningovaniya (Advanced Honing Methods), Moscow: Mashinostroenie, 1983.
Gashev, E.A., Muratov, K.R., Muratov, R.A., and Khanov, A.M., RF Patent 2 622 550, Byull. Izobret., 2016, no. 17.
Funding
The studies was carried out with the financial support of the Ministry of Science and Higher Education of the Russian Federation under the government task FSNM-2020-0028.
Author information
Authors and Affiliations
Corresponding authors
Additional information
Translated by B. Gilbert
About this article
Cite this article
Muratov, R.A., Muratov, K.R., Gashev, E.A. et al. Equipment for Honing Precision Holes. Russ. Engin. Res. 40, 857–858 (2020). https://doi.org/10.3103/S1068798X20100159
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X20100159