Abstract
The use of Co30Cr12.5W cobalt-alloy powder in laser surfacing is considered. The characteristics of the powder are determined. In laser surfacing, both individual tracks and overlapping tracks are employed. The microstructure and microhardness of the samples are assessed.
Similar content being viewed by others
REFERENCES
Shiganov, I.N., Gonsales, L.F., and Bazaleeva, K.O., The structure and properties of wear-resistant stellite coatings deposited on steel by laser, Svar. Proizvod., 2017, no. 10, pp. 18–23.
Gonsales, L.F. and Shiganov, I.N., Optimization of stellite deposition on steel by laser, Svar. Proizvod., 2017, no. 3, pp. 35–41.
Bertrand, F., Movchan, I., Samodurova, M.N., and Dzhigun, N.S., Laser surfacing as a promising method for hardening of die tooling, Vestn. Magnitogorsk. Gos. Tekh. Univ. im. G.I. Nosova, 2016, vol. 14, no. 2, pp. 44–52.
Dolgovechnyi, A.V., Demidova, L.A., and Morozov, E.A., Cladding of alloy steel on carbon steel, Izv. Samar. Nauchn. Tsentra, Ross. Akad. Nauk, 2012, vol. 14, no. 1 (2), p. 550.
Author information
Authors and Affiliations
Corresponding authors
Additional information
Translated by B. Gilbert
About this article
Cite this article
Morozov, E.A., Muratov, K.R., Shafranov, A.V. et al. Laser Surfacing with Co30Cr12.5W Cobalt-Alloy Powder. Russ. Engin. Res. 40, 890–892 (2020). https://doi.org/10.3103/S1068798X20100147
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X20100147