Abstract
The temperature is analyzed in the machining of a one-piece compressor impeller, by simulation. The results obtained by means of the proposed algorithm are presented.
Similar content being viewed by others
REFERENCES
Albagachiev, A.Yu., Krasko, A.S., and Stramtsova, E.S., Optimization of the high-speed turning of high-temperature nickel alloy, Russ. Eng. Res., 2018, vol. 38, no. 10, pp. 776–779.
Vorontsov, A.L., Albagachiev, A.Yu., and Sultan-Zade, N.M., Teoreticheskie osnovy obrabotki metallov v mashinostroenii (Theoretical Principles of Metal Processing in Machine Engineering), Staryi Oskol: TNT, 2013.
Albagachiev, A.Yu., Preobrazhenskaya, E.V., Krasko, A.S., and Stramtsova, E.S., Temperature rise in the cutting zone during the high-speed milling of heat-resistant alloys, Russ. Eng. Res., 2018, vol. 38, no. 12, pp. 1009–1011.
Silin, S.S., Metod podobiya pri rezanii materialov (Use of Similarity Method for Material Cutting), Moscow: Mashinostroenie, 1979.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated by B. Gilbert
About this article
Cite this article
Albagachiev, A.Y., Stramtsova, E.S. & Kulakov, O.I. Temperature Simulation in Machining a Compressor Impeller. Russ. Engin. Res. 40, 840–842 (2020). https://doi.org/10.3103/S1068798X20100056
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X20100056