Abstract
On the basis of experimental data, recommendations are made regarding the electric-discharge machining (EDM) of 38Х2Н2МА alloy-steel parts with improved high-temperature wear resistance. Those recommendations ensure high quality of the machined surface with the highest possible productivity. In the finishing pass, to ensure roughness Ra = 2.4, the following parameters are chosen: voltage U = 100 V; time of pulse action T = 150 µs; and current I = 6 A.
Similar content being viewed by others
REFERENCES
Nefed’ev, S.P., Materialovedenie i tekhnologiya konstruktsionnykh materialov (Material Science and Technology of Construction Materials), Magnitogorsk: Magnitogorsk. Gos. Tekh. Univ. im. G.I. Nosova, 2014.
Grigorenko, V.B., Use of corrosion-resistant steels, Stanki Instrum., 2014, no. 1, pp. 60–65.
Rebrova, I.A., Planirovnie eksperimenta: Uchebnoe posobie (Experiment Planning: Manual), Omsk: Sib. Avtom.-Dorozhn. Inst., 2010.
Petkov, A.A., Ortoganal’noe tsentral’noe kompozitsionnoe planirovanie v tekhnike i elektrofizike vysokikh napryazhenii (Orthogonal Central Composite Planning in Engineering and High Voltage Electrophysics), Kharkov: Khark. Politekh. Inst., 2007.
Funding
Financial support was provided by the Russian Ministry of Education and Science (project 11.9716.2017/8.9).
Author information
Authors and Affiliations
Corresponding authors
Additional information
Translated by Bernard Gilbert
About this article
Cite this article
Shlykov, E.S., Ablyaz, T.R. & Muratov, K.R. More Efficient Electric-Discharge Machining of 38Х2Н2МА Steel. Russ. Engin. Res. 39, 895–897 (2019). https://doi.org/10.3103/S1068798X1910023X
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X1910023X