Abstract
Software for recording machining tracks in abrasive lapping is described. The software permits prediction of the shape and magnitude of the tool’s surface wear at the stage of process design, on the basis of the dimensions of the workpiece and the lap, their relative velocity, and the machining trajectory.
Similar content being viewed by others
REFERENCES
Orlov, P.N., Tekhnologicheskoe obespechenie kachestva detalei metodami dovodki (Technological Support of Quality of the Parts by Finishing), Moscow: Mashinostroenie, 1988.
Kudoyarov, R.G., Improvement of the accuracy of the shape and surface quality of parts by diamond honing on mechatronic machines, Doctoral (Eng.) Dissertation, Ufa, 2003.
Vinokurov, S.I., Kinetics of flat surface forming, in Formoobrazovanie opticheskikh poverkhnostei (Forming of Optic Surfaces), Kumanin, K.G., Ed., Moscow: Oborongiz, 1962, pp. 331–380.
Muratov, K.R. and Gashev, E.A., Dynamics of surface shape transformation during abrasive finishing, Vestn. Yuzhno-Ural. Gos. Univ., Ser.: Mashinostr., 2014, vol. 14, no. 4, pp. 46–54.
Muratov, K.R., Influence of rigid and frictional kinematic linkages in tool–workpiece contact on the uniformity of tool wear, Russ. Eng. Res., 2016, vol. 36, no. 4, pp. 321–323.
Funding
Financial support was provided by the Russian President in encouragement of young Russian scientists (grant MD-1779.2019.8).
Author information
Authors and Affiliations
Corresponding authors
Additional information
Translated by Bernard Gilbert
About this article
Cite this article
Muratov, K.R., Ablyaz, T.R., Gashev, E.A. et al. Software for Simulating the Surface Wear of Tools. Russ. Engin. Res. 39, 869–871 (2019). https://doi.org/10.3103/S1068798X19100174
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X19100174