Abstract—In the cutting of four different alloys, the effectiveness of two machining fluids is investigated as a function of their composition and physical properties. An index characterizing the influence of each chemical element in the fluid on its effectiveness is proposed.
Similar content being viewed by others
REFERENCES
Khudobin, L.V., Babichev, A.P., Bulyzhev, E.M., et al., Smazochno-okhlazhdayushchie tekhnologicheskie sredstva i ikh primenenie pri obrabotke rezaniem: Spravochnik (Cutting Coolant Agents and Their Use in Cutting: Handbook), Khudobin, L.V., Ed., Moscow: Mashinostroenie, 2006.
Shashin, A.D., The effect of coolant on interaction between the tool and the billet during metal cutting, Cand. Sci. (Eng.) Dissertation, Moscow, 2003.
Entelis, S.G. and Berlinger, E.M., Smazochno-okhlazhdayushchie tekhnologicheskie sredstva dlya obrabotki metallov rezaniem: spravochnik (Coolants for Metal Cutting: Handbook), Moscow: Mashinostroenie, 1995.
Kisel’, A.G., The efficiency of cutting coolants for various steel 45 processing modes, in Materialy VI nauchno-prakticheskoi konferentsii “Innovatsionnye proekty i tekhnologii v obrazovanii, promyshlennosti i na transporte” (Proc. VI Sci.-Pract. Conf. “Innovative Projects and Technologies in Education, Industry, and Transport”), Omsk: Omsk. Gos. Univ. Putei Soobshch., 2014, pp. 305–316.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated by Bernard Gilbert
About this article
Cite this article
Kisel’, A.G., Rogachev, E.A., Evdokimova, O.P. et al. Influence of the Properties of Machining Fluids on the Frictional Coefficient in Alloy Turning. Russ. Engin. Res. 39, 742–744 (2019). https://doi.org/10.3103/S1068798X19090107
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X19090107