Abstract
The development and practical introduction of a robot hot-stamping system for compressor blades in gas-turbine engines is discussed. The benefits of this system are noted.
Similar content being viewed by others
REFERENCES
Kozhina, T.D., Volkov, S.A., and Sokolov, N.N., Technological support of highly efficient production of compressor blades of a strategic line of industrial gas turbine engines, Vestn. Rybinsk. Gos. Aviats. Tekh. Univ. im. P.A. Solov’eva, 2017, no. 1, pp. 20–25.
Yurevich, E.I., Osnovy robototekhniki (Fundamentals of Robotics), St. Petersburg: BKhV-Peterburg, 2005.
Korendyasev, A.I., Salamandra, B.L., and Tyves, L.I., Teoreticheskie osnovy robototekhniki (Theory of Robotics), Moscow: Nauka, 2006, book 1.
Kozhina, T.D., Sokolov, N.N., Kurochkin, A.V., et al., Complex automated production of blade blanks for GTE compressors, Vestn. Mashinostr., 2017, no. 2, pp. 51–55.
ACKNOWLEDGMENTS
Financial support was provided by the Russian Ministry of Education and Science (contract 02.G25.31.0156, December 1, 2015), within the scope of Russian government decree 218.
Author information
Authors and Affiliations
Corresponding authors
Additional information
Translated by Bernard Gilbert
About this article
Cite this article
Kozhina, T.D., Volkov, S.A. Robot Stamping System for Compressor Blades in Gas-Turbine Engines. Russ. Engin. Res. 39, 587–590 (2019). https://doi.org/10.3103/S1068798X19070098
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X19070098