Abstract
A method is proposed for calculating the limiting deviation and group tolerances when group interchangeability (selective assembly) is used. The example considered is increase in precision of the gap in the joint between a hydraulic cylinder and the piston rod.
Similar content being viewed by others
REFERENCES
Timiryazev, V.A., Voronenko, V.P., and Skhirtladze, A.G., Osnovy tekhnologii mashinostroitel’nogo proizvodstva: Uchebnik dlya vuzov (Fundamental Technology of Machine Engineering Manufacture: Manual for Higher Education Institutions), Timiryazev, V.A., Ed., St. Petersburg: Lan’, 2012.
Kershenbaum, V.Ya., Radkevich, Ya.M., Timiryazev, V.A., et al., Metrologiya i vzaimozamenyaemost’: Uchebnik dlya vuzov (Metrology and Interchangeability: Manual for Higher Education Institutions), Moscow: Ross. Gos. Univ. Nefti Gaza im. I.M. Gubkina, 2015.
Timiryazev, V.A., Khostikoev, M.Z., and Skhirtladze, A.G., Osnovy tekhnologii mashinostroeniya (Fundamental Technology of Machine Engineering), Moscow: Neft’ i Gaz, 2016.
Nabatnikov, Yu.F., Improvement of the of manufacturing accuracy of power hydrocylinders of mechanized roof supports by improvement of the assembly, Extended Abstract of Doctora; (Eng.) Dissertation, Moscow, 2012.
Timiryazev, V.A., Skhirtladze, A.G., Solnyshkin, N.P., et al., Proektirovanie tekhnologicheskikh protsessov mahsinostroitel’nykh proizvodstv: Uchebnik dlya vuzov (Engineering of Technological Processes of Machine Engineering Industries: Manual for Higher Education Institutions), St. Petersburg: Lan’, 2014.
Khostikoev, M.Z. and Timiryazev, V.A., Razmernye svyazi v mashinakh i tekhnologicheskikh protsessakh: Uchebnoe posobie (Size Relations in Machines and Technological Processes: Manual), Moscow: Neft’ i Gaz, 2013.
Author information
Authors and Affiliations
Corresponding authors
Additional information
Translated by Bernard Gilbert
About this article
Cite this article
Timiryazev, V.A., Khostikoev, M.Z., Konoplev, V.N. et al. Improving Precision in Selective Assembly. Russ. Engin. Res. 39, 499–502 (2019). https://doi.org/10.3103/S1068798X19060182
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X19060182