Abstract—
A method is proposed for monitoring the cemented layer of hardened steel parts. Specifically, in the chip obtained on turning a solid of revolution by a pass-through cutter, the width of the corrugated section is measured, by means of sliding calipers or by photography.
Similar content being viewed by others
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated by Bernard Gilbert
About this article
Cite this article
Perminov, A.E., Ignatov, M.G. & Prokof’ev, E.Y. Rapid Monitoring of the Hardened-Layer Depth on a Steel Part. Russ. Engin. Res. 39, 394–395 (2019). https://doi.org/10.3103/S1068798X19050162
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X19050162