Skip to main content
SpringerLink
Log in

Resultant Cutting Trajectories on Machine Tools with Raster Tool Motion

  • Published:
Russian Engineering Research Aims and scope

Abstract

The formation of the resultant raster trajectories in machine tools are established on the basis of Lissajous figures, taking account of additional workpiece motion for finishing purposes. Kinematic and geometric formulas are obtained for the relative tool and workpiece trajectory with strict kinematic coupling. These formulas are required in practice for abrasive lapping. They permit control of the resultant abrasive-cutting trajectory in finishing the precision planes of the workpiece.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1.
Fig. 2.
Fig. 3.

Similar content being viewed by others

REFERENCES

  1. Muratov, K.R., Influence of rigid and frictional kinematic linkages in tool–workpiece contact on the uniformity of tool wear, Russ. Eng. Res., 2016, vol. 36, no. 4, pp. 321–323.

    Article  Google Scholar 

  2. Nekrasov, V.P., The study of raster finishing and patterns of formation of flat surfaces, Cand. Sci. (Eng.) Dissertation, Perm, 1971.

Download references

ACKNOWLEDGMENTS

Financial support was provided by the Russian Ministry of Education and Science (project 11.976.2017/BCh).

Author information

Authors and Affiliations

  1. Perm National Research Polytechnic University, Perm, Russia

    K. R. Muratov, E. A. Gashev, T. R. Ablyaz, L. D. Sirotenko, E. V. Matygullina & D. M. Lagunov

Authors
  1. K. R. Muratov
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. E. A. Gashev
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. T. R. Ablyaz
    View author publications

    You can also search for this author in PubMed Google Scholar

  4. L. D. Sirotenko
    View author publications

    You can also search for this author in PubMed Google Scholar

  5. E. V. Matygullina
    View author publications

    You can also search for this author in PubMed Google Scholar

  6. D. M. Lagunov
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding authors

Correspondence to K. R. Muratov, E. A. Gashev, T. R. Ablyaz, L. D. Sirotenko, E. V. Matygullina or D. M. Lagunov.

Additional information

Translated by Bernard Gilbert

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Muratov, K.R., Gashev, E.A., Ablyaz, T.R. et al. Resultant Cutting Trajectories on Machine Tools with Raster Tool Motion. Russ. Engin. Res. 38, 1071–1073 (2018). https://doi.org/10.3103/S1068798X18120274

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.3103/S1068798X18120274

Keywords:

Search

Navigation