Abstract
Standard operating conditions of ball end mills are considered. A set of surfaces whose machining simulates the production of complex curved shapes is formulated. Surfaces for duration tests of the spherical part of ball end mills are selected.
Similar content being viewed by others
REFERENCES
Golubev, S.A., The influence of the inclination angle of the screw teeth of the cutters on durability, Stanki Instum., 1959, no. 10, pp. 34–35.
Semenchenko, I.I., Matyushkin, V.M., and Sakharov, G.N., Proektirovanie metallorezhushchikh instrumentov: uchebnoe posobie (Engineering of Metal Cutting Tools: Manual), Moscow: Mashgiz, 1963.
Lunev, A.N. and Moiseeva, L.T., Calculation of geometry of stamps with small allowances for pieces of the aerodynamic profile, Izv. Vyssh. Uchebn. Zaved., Aviats. Tekh., 1994, no. 1, pp. 99–102.
Grechishnikov, V.A., Khusainov, R.M., Akhkiya-mov D.R., et al., Identifying the primary rigidity axes in the elastic system of a metal-cutting machine, Russ. Eng. Res., 2016, vol. 36, no. 8, pp. 673–676.
Korovin, E.M., Lunyov, A.N., and Khasanov, R.Sh., Optimization of cutting parameters for automatic machines, Russ. Aeronaut., 2006, vol. 49, no. 4, pp. 100–105.
Kondrashov, A.G., Safarov, D.T., Faskhutdinov, A.I., and Davletshina, G.K., Single-turn worm mills for conical round-tooth gears, Russ. Eng. Res., 2017, vol. 37, no. 9, pp. 812–813.
Sedov, B.E. and Romanov, V.B., The effect of forming plane cutter on the geometric parameters and the error profile, Vestn. Mashinostr., 2003, no. 11, pp. 58–60.
Sedov, B.E. and Romanov, V.B., Profiling and grinding of geometrically precise cutter with shaped frontal surface, Spravochnik. Inzh. Zh., 2005, no. 8, pp. 5–13.
Sedov, B.E. and Romanov, V.B., Profiling of spur geometrically precise cutters, Stanki Instum., 2005, no. 9, pp. 6–9.
Sedov, B.E. and Romanov, V.B., Improving the profiling accuracy of spur cutters, Stanki Instum., 2004, no. 9, pp. 21–24.
Grechishnikov, V.A., Romanov, V.B., et al., Design of butter profile with custom geometrical parameters, Vestn. Mosk. Gos. Tekhnol. Univ., Stankin, 2012, no. 4 (23), pp. 15–17.
Author information
Authors and Affiliations
Corresponding authors
Additional information
Translated by Bernard Gilbert
About this article
Cite this article
Ryabov, E.A., Khisamutdinov, R.M., Grechishnikov, V.A. et al. Selection of Surfaces for Endurance Tests of Ball End Mills. Russ. Engin. Res. 38, 1012–1014 (2018). https://doi.org/10.3103/S1068798X18120158
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X18120158