Abstract
In research on thread cutting, the flaws inevitably arising in the first two and last two turns of the thread, when the process is unsteady, are analyzed. Specifically, insertion and removal of the tool from the workpiece are accompanied by abrupt change in thread diameter: abrupt decrease in the case of threads on shafts; and increase for threads in holes. That leads to the appearance of slots on assembly, thereby increasing the likelihood of accidents and other problems in thread operation. A method of eliminating such gaps is proposed and tested: control of the machining precision in the course of thread cutting. In particular, the thread diameter and pitch are controlled by compensation of the axial and radial elastic displacements of the tool, based on timely correction of the transverse and longitudinal supply during the unsteady stage of the process. Compensation of the machining errors improves the dimensional precision of the thread and decreases the systematic errors and spread in the thread dimensions.
Similar content being viewed by others
REFERENCES
Borovskoi, G.V., Razvitie mashinostroeniya Rossii na osnove tekhnologicheskogo perevooruzheniya (Development of Machine Engineering in Russia Based on Technological Optimization), Moscow: Instrumenty, Tekhnologiya, Oborudovanie, 2009.
Timiryazev, V.A., Khostikoev, M.Z., and Skhirtladze, A.G., Osnovy tekhnologii mashinostroeniya (Fundamental Technology of Machine Engineering), Moscow: Neft’ i Gaz, 2016.
Grechishnikov, V.A., Nauka i iskusstvo sistemnogo modelirovaniya instrumental’nogo obespecheniya mashinostroitel’nykh proizvodstv (Science and Art of System Modeling of Instrumental Support of Machine Engineering Industry), Moscow: Kursk, 2016.
Kuznetsov, A.M. and Orlov, E.M., Dynamics and errors in processing of instable threading process, Trudy XXXIX mezhdunarodnoi nauchno-tekhnicheskaya konferentsii Assotsiatsii Avtomobil’nykh Inzhenerov (Proc. XXXIX Int. Sci.-Tech. Conf. of Automotive Engineers Association), Moscow: Mosk. Gos. Tekh. Univ., MAMI, 2002.
Timiryazev, V.A. and Khostikoev, M.Z., Automatic assessment of cutting tools on multipurpose machines, Izv. Mosk. Gos. Tekh. Univ., MAMI, 2011, no. 1 (11), pp. 198–202.
Khostikoev, M.Z., Golobova, A.A., and Chertov, F.N., Computer automated reduction of the installation error of the cutting tool on multipurpose machines, Vestn. Mosk. Gos. Tekhnol. Univ., Stankin, 2011, no. 4 (17), pp. 43–45.
Khostikoev, M.Z., Control of tool geometry during machining, Gorn. Inf.-Anal. Byull., 2011, no. 4, pp. 319–321.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated by Bernard Gilbert
About this article
Cite this article
Khostikoev, M.Z., Timiryazev, V.A. & Orlov, E.M. Control of the Machining Precision in Thread Cutting. Russ. Engin. Res. 38, 1022–1025 (2018). https://doi.org/10.3103/S1068798X18120109
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X18120109