Abstract
The use of a replaceable polyhedral insert in burnishing is considered. Specifically, the influence of the insert’s configuration on the surface quality of a steel surface after burnishing is studied in complete factorial experiments. The surface quality is assessed in terms of the mean deviation Ra of the profile; the profile’s relative reference length tp (p = 5%); the mean spacing Sm of the microprojections; and the mean spacing S of local projections. The parameters considered in determining the configuration the burnishing tool (replaceable polyhedral insert) are the interference i, the positional angle φ' of the tool around the vertical axis; and its positional angle ψ around the horizontal axis.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
REFERENCES
Zubkov, E.I., The efficiency improvement of smoothing of the outer cylindrical surfaces by a tool from mineral ceramics, Cand. Sci. (Eng.) Dissertation, Moscow, 1992.
Kuznetsov, V.A., Sistemnyi analiz i modelirovanie metodov obrabotki: Monografiya (System Analysis and Modeling of Processing Methods: Monograph), Saarbrucken: LAP Lambert Academic, 2013.
Kuznetsov, V.A., Shestavin, P.V., Smirnov, A.V., and Sazonov, D.A., Smoothing of parts by polyhedral unrebinded plates, Avtomob. Prom-st., 2010, no. 10, p. 24.
Smirnov, A.V., Quality support of external cylindrical surfaces by smoothing by replaceable polyhedral plates, Cand. Sci. (Eng.) Dissertation, Moscow, 2014.
Author information
Authors and Affiliations
Corresponding authors
Additional information
Translated by Bernard Gilbert
About this article
Cite this article
Smirnov, A.V., Kuznetsov, V.A. Influence of Insert Configuration on the Product’s Surface Quality in Burnishing. Russ. Engin. Res. 38, 892–895 (2018). https://doi.org/10.3103/S1068798X18110151
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X18110151