Abstract
Screw turns are known to be deformed as a result of the contact pliability of the nut and screw surfaces. The load distribution over the turns is investigated when fine thread is employed, when compression nuts are replaced by tension–compression and tension nuts, when the roughness of the working surfaces is increased, and when the load on the screw is increased.
Similar content being viewed by others
References
Zhukovskii, N.E., Distribution of pressures in thread of screw and screw-nuts, Byull. Politekh. O-va, 1902, no. 1, pp. 1–3.
Malygin, V.I., Kremleva, L.I., Lobanov, N.V., et al., Distribution of loads in the threads of the bolted connections of assembled propellers, Tyazh. Mashinostr., 2014, no. 8, pp. 25–29.
Birger, I.A., Raschet rez’by soedinenii (Claculation of Threaded Connections), Moscow: Oborongiz, 1959.
Kuklin, V.B., Corrected calculation of threaded connections, Vestn. Mashinostr., 1957, no. 7, pp. 24–30.
Ivanov, A.S., Baikov, B.A., and Shchegolev, N.A., Correction of distribution of the load in the threaded connection through the threads by their contact stiffness, Vestn. Mashinostr., 2004, no. 4, pp. 20–23.
Ivanov, A.S. and Murkin, S.V., Raschet i proektirovanie rez’bovykh soedinenii privodov (Calculation and Engineering of Threaded Connections of Drives), Moscow: Innovatsionnoe Mashinostr., 2015.
Wiegand, H. and Illgner, K.-H., Berechnung und Gestaltung von Schraubenverbindungen, Berlin: Springer-Verlag, 1962.
Niemann, G., Winter, H., and Huhn, B.-R., Maschinenelemente, Vol. 1: Konstruktion und Berechnung von Verbindungen, Lagern, Wellen, Berlin: Springer-Verlag, 2001, 3rd ed.
Jovanovic, J.D., Finite element analysis of bolted joint with coarse and fine threads, Proc. 14th Int. Research. Expert Conf. “Trends in the Development of Machinery and Associated Technology, TMT 2010,” September 11–18, 2010, Venice, 2010.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © A.S. Ivanov, O.B. Koroleva, 2017, published in Vestnik Mashinostroeniya, 2017, No. 12, pp. 10–13.
About this article
Cite this article
Ivanov, A.S., Koroleva, O.B. Influence of Nut Design on the Load Distribution over the Turns of a Screw. Russ. Engin. Res. 38, 147–150 (2018). https://doi.org/10.3103/S1068798X1803005X
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X1803005X