Abstract
A method is proposed for determining the cutter profile of a mill.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Grechishnikov, V.A., Profilirovanie instrumenta dlya obrabotki vintovoi poverkhnosti detail po metodu sovmeshchennykh sechenii: uchebnoe posobie (Tool Profiling for Treatment of Screw Surface of the Workpieces by Combined Cross-Section Method), Moscow, 1979.
Grechishnikov, V.A., Chemborisov, N.A., Akhmetshin, I.R., and Nizamov, A.Kh., Computer simulation of combined cross-sections for determination of the disk tool profile processing the screw surfaces of workpieces, Nauchno-tekhnicheskaya konferentsiya “Tekhnologicheskie problemy proizvodstva letatel’nykh apparatov i dvigatelei,” Tezisy dokladov (Sci.-Tech. Conf. “Technological Problems in Production of Aircrafts and Engines,” Abstracts of Papers), Kazan: Kazan. Gos. Tekh. Univ., 1993.
Yunusov, F.S., Chemborisov, N.A., and Petrov, S.M., Computer simulation of the treatment of screw surface of the workpiece by disk tool, Vestn. Kazan. Gos. Tekh. Univ. im. A.N. Tupoleva, 1996, no. 4. pp. 13–18.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © S.M. Petrov, G.K. Davletshina, B.F. Zairov, L.F. Zairov, 2017, published in STIN, 2017, No. 3, pp. 17–19.
About this article
Cite this article
Petrov, S.M., Davletshina, G.K., Zairov, B.F. et al. Cutter profile of a mill for machining screw channels. Russ. Engin. Res. 37, 728–729 (2017). https://doi.org/10.3103/S1068798X17080147
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X17080147