Abstract
The use of one- and two-sided cutting heads to ensure that the longitudinal tooth curvature resembles logarithmic and Archimedes spirals is considered. The influence of such shaping on the operational reliability of conical and hypoid gears with round teeth is assessed.
Similar content being viewed by others
References
Sheveleva, G.I., Volkov, A.E., and Medvedev, V.I., Software for the production of conical and hypoid gears with circular teeth, Tekhn. Mashinostr., 2001, no. 2, pp. 40–51.
Klingenberg, J., Kegelrader, Berlin: Springer-Verlag, 2008.
Kalashnikov, A.S., Morgunov, Yu.A., and Kalashnikov, P.A., Reduction of the complexity of assembly of conical and hypoid gears, Vestn. Mashinostr., 2014, no. 10, pp. 63–65.
Kalashnikov, A.S., Morgunov, Yu.A., and Kalashnikov, P.A., Cog fitting and grinding of conical and hypoid gears, Spravochnik. Inzh. Zh., 2011, no. 3, pp. 3–7.
Astakhov, Yu.P., Kochergin, S.A., Morgunov, Yu.A., and Saushkin, B.P., Efficiency improvement of manufacturing monowheel blades, Tekhnol. Mashinostr., 2013, no. 5, pp. 14–18.
Astakhov, Yu.P., Kochergin, S.A., and Mitryushin, E.A., Microprocessing of surface reliefs using physical and chemical methods of influence on a material, Naukoemkie Tekhnol. Mashinostr., 2012, no. 7, pp. 33–38.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © A.S. Kalashnikov, P.A. Kalashnikov, N.V. Khomyakova, 2017, published in Vestnik Mashinostroeniya, 2017, No. 4, pp. 57–62.
About this article
Cite this article
Kalashnikov, A.S., Kalashnikov, P.A. & Khomyakova, N.V. Cutting-head optimization to improve the reliability of conical and hypoid gears. Russ. Engin. Res. 37, 603–607 (2017). https://doi.org/10.3103/S1068798X17070140
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X17070140