Abstract
In a well-chosen hobbing configuration, the hazardous tensile stresses in hard-alloy inserts are significantly less than in the standard configuration.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Artamonov, E.V., Prochnost’ i rabotosposobnost’ smennykh tverdoslavnykh plastin sbornykh rezhushchikh instrumentov (Strength and Performance of Replaceable Hard-Alloy Plates in Composite Tools), Tyumen: Tyumen. Gos. Neftegaz. Univ., 2003.
Artamonov, E.V., Pomigalova, T.E., and Uteshev, M.Kh., Raschet i proektirovanie smennykh rezhushchikh plastin i sbornykh instrumentov (Calculation and Engineering of Replaceable Cutting Plates and Composite Tools), Tyumen: Tyumen. Gos. Neftegaz. Univ., 2011.
Artamonov, E.V. and Vasil’ev, D.V., Determining the optimal cutting speed in turning by composite cutters on the basis of the chip, Russ. Eng. Res., 2014, vol. 34, no. 6, pp. 404–405.
Artamonov, E.V., Vasilega, D.S., and Tveryakov, A.M., Determining the maximum-performance temperature of hard-alloy cutting plates, Russ. Eng. Res., 2014, vol. 34, no. 6, pp. 402–403.
Polokhin, O.V., Tarapanov, A.S., and Kharlamov, G.A., Narezanie zubchatykh profilei instrumentami chervyachnogo tipa: spravochnik (Hob Cutting of Tooth Profiles: A Handbook), Kharlamov, G.A., Ed., Moscow: Mashinostroenie, 2007.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © E.V. Artamonov, V.V. Kireev, V.A. Zyryanov, 2016, published in STIN, 2016, No. 11, pp. 21–24.
About this article
Cite this article
Artamonov, E.V., Kireev, V.V. & Zyryanov, V.A. Improving the efficiency of hobbing mills. Russ. Engin. Res. 37, 447–449 (2017). https://doi.org/10.3103/S1068798X17050057
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X17050057