Abstract
The end milling of industrial and engineering thermoplastics on numerically controlled machine tools is considered. Specifically, attention focuses on the sources and prevention of machining defects. Recommendations are made regarding the selection of the tool geometry, the cutting conditions, and the mill trajectory.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Selection of cutting modes for Gravman tools. http://www.gravman.ru.
Billets from technical polymers, Catalog Ensinger, 2012. http://www.ensinger-online.com.
Cutting modes during milling on milling-engraving machines. http://www.bzt-cnc.ru.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © A.A. Emel’yanenko, O.I. Zhabin, Yu.N. Polyanchikov, 2016, published in Vestnik Mashinostroeniya, 2016, No. 11, pp. 68–71.
About this article
Cite this article
Emel’yanenko, A.A., Zhabin, O.I. & Polyanchikov, Y.N. Programmable end milling of thermoplastics. Russ. Engin. Res. 37, 122–124 (2017). https://doi.org/10.3103/S1068798X1702006X
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X1702006X