Abstract
Current cutting standards associated with tool failure and tool efficiency are analyzed. The Taylor power law relating the operating conditions of the tool to the outcome is appraised. The Taylor law is only applicable within a limited range and cannot be used in determining the optimal cutting conditions.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Loktev, A.D., Gushchin, I.F., Balashov, B.N., et al., Obshchemashinostroitel’nye normativy rezhimov rezaniya: Spravochnik (General Machine Engineering Standards of Cutting Regimes: Handbook), Moscow: Mashinostroenie, 1991.
Pukhal’skii, V.A., Selection of a target parameter for evaluation of efficiency of cutting instrument, Vestn. Mashinostr., 2006, no. 8, pp. 54–57.
Granovskii, G.I., Obrabotka rezul’tatov eksperimental’nykh issledovanii rezaniya metallov (The Treatment of Experimental Results of Metal Cutting), Moscow: Mashinostroenie, 1982.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © D.M. Zabel’yan, 2015, published in STIN, 2015, No. 11, pp. 31–33.
About this article
Cite this article
Zabel’yan, D.M. Analysis of current cutting standards. Russ. Engin. Res. 36, 506–507 (2016). https://doi.org/10.3103/S1068798X16060216
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X16060216