Abstract
A method is proposed for determining the geometric parameters of the cutting section in an abrasive grain.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Korolev, A.V. and Novoselov, Yu.K., Teoretiko-veroyatnostnye osnovy abrazivnoi obrabotki. Ch. 1. Sostoyanie rabochei poverkhnosti instrumenta (Probabilistic Principles of Abrasive Machining, Vol. 1: State of the Tool’s Working Surface), Saratov: Izd. Saratovsk. Univ., 1987.
Korolev, A.V. and Novoselov, Yu.K., Teoretiko-veroyatnostnye osnovy abrazivnoi obrabotki. Ch. 2. Vzaimodeistvie instrumenta i zagotovki pri abrazivnoi obrabotke (Probabilistic Principles of Abrasive Machining, Vol. 2: Tool–Blank interaction in Abrasive Machining), Saratov: Izd. Saratovsk. Univ., 1989.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © A.V. Korolev, O.P. Reshetnikova, A.S. Noskov, 2015, published in STIN, 2015, No. 5, pp. 2–7.
About this article
Cite this article
Korolev, A.V., Reshetnikova, O.P. & Noskov, A.S. Cutting geometry of abrasive grains. Russ. Engin. Res. 35, 850–854 (2015). https://doi.org/10.3103/S1068798X1511009X
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X1511009X