Abstract
Grinding of the ends of lithium-niobate monocrystalline plates by bound abrasive is considered. The diamond laps employed are based on ASN micropowder (grain size 10/7), with organic and metallic binders. In grinding by laps with organic binder, the rate at which material is removed is 16–20% higher than for laps with metallic binder. The roughness of the ground end surfaces of the lithium-niobate monocrystalline plates is practically independent of the applied pressure and the cutting speed.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Ardamatskii, A.L., Almaznaya obrabotka opticheskikh detalei (Diamond Machining of Optical Parts), Leningrad: Mashinostroenie, 1978.
Lepitova, N.P., Diamond machining of glass, Sinteticheskie almazy v promyshlennosti (Synthetic Diamonds in Industry), Kiev: Naukova Dumka, 1974, pp. 288–290.
Formoobrazovanie opticheskikh poverkhnostei (Shaping of Optical Surfaces), Kumanin, K.G., Ed., Kiev: Naukova Dumka, 1962.
Osnovy proektirovaniya i tekhnologiya izgotovleniya abrazivnogo i almaznogo instrumenta (Fundamentals of the Design and Manufacture of Abrasive and Diamond Tools), Bakul’, V.N., Ed., Moscow: Mashinostroenie, 1975.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © K.R. Muratov, A.M. Khanov, E.A. Gashev, 2015, published in STIN, 2015, No. 4, pp. 16–18.
About this article
Cite this article
Muratov, K.R., Khanov, A.M. & Gashev, E.A. Grinding of single crystals by bound abrasive. Russ. Engin. Res. 35, 777–779 (2015). https://doi.org/10.3103/S1068798X15100147
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X15100147