Abstract
Computer simulation of the stamping of thin-walled parts with engraving and reinforcing ribs is considered, on the basis of the behavior of sand.
Similar content being viewed by others
References
Chumachenko, E.N., Smirnov, O.M., and Tsepin, M.A., Sverkhplastichnost’: materialy, teoriya, tekhnologii (Superplasticity: Materials, Theory, Technology), Moscow: LIBROKOM, 2009.
Chumachenko, E.N. and Logashina, I.V., Matematicheskoe modelirovanie i optimizatsiya protsessov deformirovaniya materialov pri obrabotke davleniem (Simulation and Optimization of Deformation Processes in Pressure Machining), Moscow: EKOMET, 2008.
Il’yushin, A.A., Theory of the flow of plastic materials at surfaces, Prikl. Matem. Mekhan., 1954, vol. 18, no. 3, pp. 265–288.
Il’yushin, A.A., Total plasticity in flow between rigid surfaces, by analogy with the behavior of sand, Prikl. Matem. Mekhan., 1955, vol. 19, no. 6, pp. 693–713.
Solomonov, K.N., Svirin, V.V., and Frolov, A.I., Using CAD systems in applied problems, SAPR Graf., 2011, no. 2, pp. 88–90.
Kiiko, I.A., Flow of a thin plastic layer along an elastically deformed surface, Inzh. Zh., 1965, vol. 5, no. 2, pp. 372–275.
Kiiko, I.A., Flow between parallel planes of a plastically anisotropic layer in a region with a sink, Vestn. Mosk. Univ., Ser. 1, Matem. Mekhan., 2013, no. 3, pp. 35–38.
Kiiko, I.A., Form of a plastic layer compressed by parallel planes, Prikl. Matem. Mekhan., 2011, vol. 75, no. 1, pp. 15–26.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © E.N. Chumachenko, V.N. Korzo, L.P. Stepanenkova, 2015, published in Vestnik Mashinostroeniya, 2015, No. 2, pp. 84–88.
About this article
Cite this article
Chumachenko, E.N., Korzo, V.N. & Stepanenkova, L.P. Stamping of long forgings. Russ. Engin. Res. 35, 358–362 (2015). https://doi.org/10.3103/S1068798X15050093
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X15050093