Abstract
A method of determining the constants for the T-Q characteristic in the machining of elementary surfaces is considered. As an example, the method is applied to the turning of an external cylindrical surface by the plate of a composite cutter.
Similar content being viewed by others
References
Svirshchev, V.I., Flegentov, V.K., Podbornov, I.V., and Savlov, A.N., Well-founded choice of the cutting plate in a composite cutter when machining elementary surfaces, Stanki Instrum., 2013, no. 12, pp. 14–17.
Spravochnik tekhnologa-mashinostroitelya (Manufac-turing Handbook), Dal’skii, A.M., Ed., Moscow: Mashinostroenie, 2003, vol. 2.
Author information
Authors and Affiliations
Corresponding author
About this article
Cite this article
Svirshchev, V.I., Savlov, A.N., Flegentov, V.K. et al. Determining the constants for the T-Q characteristic in the machining of elementary surfaces. Russ. Engin. Res. 35, 209–211 (2015). https://doi.org/10.3103/S1068798X15030181
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X15030181