Abstract
A method is proposed for automated determination and prediction of the position of the most loaded hob teeth. Experiments confirm the validity of the proposed mathematical model.
Similar content being viewed by others
References
Medveditskov, S.N., Narozhnykh, A.T., Skrebnev, G.G., and Churbakov, V.F., Method calculating the correction parameters for hobs with a complex cutting configuration, Tekhnologiya i avtomatiztsiya mashinostroitel’nogo proizvodstva. Nauch. tr. Volgogradskogo politekhn. instituta (Manufacturing Technology and Automatic Systems: Proceedings of Volgograd Polytechnic Institute), Volgograd: VPI, 1975, no. 6, pp. 26–31.
Bashkirov, V.N. and Serova, A.A., Determining the cut cross section in the hobbing of cylindrical gears, Stanki Instrum., 1984, no. 1, pp. 18–20.
Tokarev, V.V., Mathematical Model of the Hobbing Geometry: Metrological Aspects and Algorithms, Cand. Sci. Dissertation, Volgograd State Technical University, Volgograd, 1998.
Loladze, T.N., Prochnost’ i iznosostoikost’ rezhushchego instrumenta (Strength and Wear Resistance of Cutting Tools), Moscow: Mashinostroenie, 1982.
Pekelharing, A.J., The exit failure in interrupted cutting, CIRP Ann., 1978, vol. 27,no. 1, pp. 5–10.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © G.G. Skrebnev, A.S. Anan’ev, 2014, published in Vestnik Mashinostroeniya, 2014, No. 8, pp. 28–34.
About this article
Cite this article
Skrebnev, G.G., Anan’ev, A.S. Load distribution between hob teeth. Russ. Engin. Res. 34, 680–686 (2014). https://doi.org/10.3103/S1068798X14110185
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X14110185