References
Lopadze, T.N., Prochnost’ i iznosostoikost’ rezhushchego instrumenta (Strength and Wear Resistance of Cutting Tools), Moscow: Mashinostroenie, 1982.
Andreev, G.S., Thermal Phenomena in the Cutting Section of a Tool in Discontinuous Cutting, Vestn. Mashinostr., 1973, no. 3, pp. 69–73.
Berdnikov, L.N., Influence of the Temperature Difference on the Brittle Failure of Hard-Alloy Mill Teeth, Stanki Instrum., 1985, no. 5, pp. 23–24.
Orady, E. and Ilusty, I., Effect of Thermal Cycling on Tool Wear in Milling, SME Manuf. Eng. Trans., 1981, vol. 9, pp. 19–22.
Wirkung von Schnitiefensch wankungen bein Drehen mit Beschichtetem Hartmetall, WT. Z. Ind. Fertigung, 1985, no. 5, pp. 287–290.
Titanonitride Beschichtete Schaftfraser mit Abgestimmter Schneidengeometrie, WT. Z. Ind. Fertigung, 1986, no. 76, pp. 227–231.
Murarka, P., Hinduja, S., and Barrow, G., Influence of Strain, Strain State and Temperature on the Flow Stress in the Primary Deformation Zone in Metal Cutting, Int. J. Mach. Tool Des. Res., 1981, vol. 21, no. 3/4, pp. 207–216.
Author information
Authors and Affiliations
Additional information
Original Russian Text © V.A. Solodkov, M.A. Tibirkova, 2012, published in STIN, 2012, No. 6, pp. 25–27.
About this article
Cite this article
Solodkov, V.A., Tibirkova, M.A. Influence of solid lubricants on the wear at the rear surface of hard-alloy tools in discontinuous cutting. Russ. Engin. Res. 33, 48–50 (2013). https://doi.org/10.3103/S1068798X13010085
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X13010085