Abstract
The stage of broaching in which the blank height is increased is analyzed. Formulas for calculating the corresponding dimensions and shape of the blank are derived.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Vorontsov, A.L., A New Method of Solving Complex Variational Problems, for the Example of Broaching, Vestn. Mashinostr., 2012, no. 1, pp. 73–77.
Vorontsov, A.L., Formation of the Blank’s Concave Upper End in Broaching, Vestn. Mashinostr., 2012, no. 2, pp. 61–64.
Vorontsov, A.L., Reduction of Blank Height on Broaching, Vestn. Mashinostr., 2012, no. 3.
Vorontsov, A.L., Tekhnologicheskie zadachi teorii plastichnosti (Technological Problems in Plasticity Theory), Moscow: Mashinostroenie, 2006, vol. 2.
Vorontsov, A.L., Teoriya malootkhodnoi shtampovki (Theory of Low-Waste Stamping), Moscow: Mashinostroenie, 2005.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © A.L. Vorontsov, 2012, published in Vestnik Mashinostroeniya, 2012, No. 4, pp. 81–83.
The present article marks the continuation of a series. The previous articles may be found in Vestnik Mashinostroenie, nos. 1–3, 2012. The next will appear in Vestnik Mashinostroenie, no. 5, 2012.
About this article
Cite this article
Vorontsov, A.L. A new method of solving complex variational problems: Increase in blank height on broaching. Russ. Engin. Res. 32, 380–382 (2012). https://doi.org/10.3103/S1068798X12040284
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X12040284