Abstract
Hybrid drawing is considered: specifically, preliminary deformation with the formation of longitudinal chip-separation channels and subsequent cutting. Optimal tool characteristics are established for each stage in drawing ductile materials and regular materials.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Loladze, T.N., Prochnost’ i iznostoikost’ rezhushchego instrumenta (Strength and Wear Resistance of Cutting Tools), Moscow: Mashinostroenie, 1982.
Gorshkov, B.T., Spravochnik po otdelke sortovogo prokata (Handbook on Trimming Rolled Rod), Moscow: Metallurgiya, 1978.
Shchedrin, A.V., Bekaev, A.A., et al., Tribological Principles in the Design of Competitive Technological Systems, Remont, Vosstanovl., Modern., 2009, no. 4, pp. 15–20.
Shchedrin, A.V., Bekaev, A.A., Skoromnov, V.M., et al., Promising Methods of Hybrid Drawing, Proizv. Prokata, 2007, no. 10, pp. 25–28.
Shchedrin, A.V., Bekaev, A.A., Skoromnov, V.M., et al., Improving Hybrid Reduction and Broaching Methods, Metallurg, 2005, no. 10, pp. 66–69.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © A.V. Shchedrin, A.A. Bekaev, G.K. Sumele, 2010, published in Vestnik Mashinostroeniya, 2010, No. 11, pp. 74–76.
About this article
Cite this article
Shchedrin, A.V., Bekaev, A.A. & Sumele, G.K. Influence of the blank’s properties on the hybrid drawing of long profiles. Russ. Engin. Res. 30, 1137–1140 (2010). https://doi.org/10.3103/S1068798X10110146
Received:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X10110146