Abstract
The drilling of holes in continuous-casting rollers with cutting and surface plastic deformation by means of a combined tool is described. Such machining ensures high productivity and low cost, with specified quality.
Similar content being viewed by others
References
Uprochnenie i otdelka detalei poverkhnostnym plasticheskim deformirovaniem: Spravochnik (Hardening and Finishing by Surface Plastic Deformation: A Handbook), Moscow: Mashinostroenie, 1987.
Kudryavtsev, I.V. and Burmistrova, L.N., Selection of the Basic Hardening Parameters of Shafts by Roller Burnishing, Vestn. Mashinostr., 1983, no. 4, pp. 8–10.
Malyshko, I.A., Osevye kombinirovannye instrumenty (rekomendatsii po proektirovaniyu i ekspluatatsii) (Axial Combined Tools: Recommendations on Their Design and Use), Donetsk: PKTI, 1996.
Proskuryakov, Yu.G. and Men’shakov, V.M., Surface Microgeometry in Machining by Strengthening and Smoothing, Vestn. Mashinostr., 1961, no. 8, pp. 51–53.
Shchedrin, A.V., Bogdanov, A.G., Taranenko, G.V., et al., Elements of a Systemic-Structural Approach to the Design of Deformation and Cutting Processes, Trakt. Sel’skokhoz. Mash., 1995, no. 10, pp. 34–36.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © A.I. Rubakhin, 2010, published in Vestnik Mashinostroeniya, 2010, No. 7, pp. 51–53.
About this article
Cite this article
Rubakhin, A.I. Combined tool for machining deep holes in continuous-casting rollers. Russ. Engin. Res. 30, 693–694 (2010). https://doi.org/10.3103/S1068798X10070105
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X10070105