Abstract
A theory of the upsetting of a low-plasticity core within a plastic hoop is developed. All the formulas required for the successful design of such a process are derived. The accuracy and reliability of the formulas are confirmed by comparison with experimental data.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Vorontsov, A.L., Upsetting of Low-Plasticity Materials within Plastic Casings, Vestn. Mashinostr., 2009, no. 3.
Vorontsov, A.L., Teoriya malootkhodnoi shtampovki (Theory of Low-Waste Stamping), Moscow: Mashinostroenie, 2005.
Malinin, N.N., Prikladnaya teoriya plastichnosti i polzuchesti (Applied Theory of Plasticity and Creep), Moscow: Mashinostroenie, 1975.
Kolmogorov, V.L., Napryazheniya, deformatsii, razrushenie (Stress, Deformation, Failure), Moscow: Metallurgiya, 1970.
Moguchii, L.N., Obrabotka davleniem trudnodeformiruemykh materialov (Pressure Treatment of Hard-To-Deform Materials), Moscow: Mashinostroenie, 1976.
Author information
Authors and Affiliations
Additional information
Original Russian Text © A.L. Vorontsov, 2009, published in Vestnik Mashinostroeniya, 2009, No. 4, pp. 68–73.
About this article
Cite this article
Vorontsov, A.L. Upsetting of low-plasticity materials within plastic hoops. Russ. Engin. Res. 29, 490–495 (2009). https://doi.org/10.3103/S1068798X09050141
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X09050141