Abstract
A reamer equipped with diamond bars of different grain size is described. Optimization of the reamer structure and geometry and also the preliminary hole diameter is considered, when different precision is required. The operating conditions and size of the diamond grains affect the reamer performance; recommendations for their selection are offered. The use of the new tool in machining precision holes is considered for various examples.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Fragin, I.E., Novie v khoningovanii (New Developments in Honing), Moscow: Mashinostroenie, 1980.
Kholmogortsev, Yu.P. and Ustimov, E.S., Diamond Reaming of Precision Holes in Structural Materials, Vestn. Mashinostr., 2006, no. 6, pp. 47–53.
Myagkov, V.D., Palei, M.A., Romanov, A.B., and Braginskii, V.A., Dopuski i posadki: Spravochnik (Tolerances and Fit: A Handbook), Leningrad: Mashinostroenie, 1982, vol. 1.
Naerman, M.S. and Popov, S.A., Pretsizionnaya obrabotka detalei almaznymi i abrazivnymi bruskami (Precision Machining of Parts by Diamond and Abrasive Bars), Moscow: Mashinostroenie, 1971.
Author information
Authors and Affiliations
Additional information
Original Russian Text © Yu.P. Kholmogortsev, 2009, published in Vestnik Mashinostroeniya, 2009, No. 4, pp. 59–66.
About this article
Cite this article
Kholmogortsev, Y.P. Optimizing the diamond reaming of precision holes. Russ. Engin. Res. 29, 375–382 (2009). https://doi.org/10.3103/S1068798X0904011X
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X0904011X