Abstract
A new method that allows one to switch the operational modes (start, speedup, retardation, reverse, steady state, stop) of an automatic electric drive has been developed. It is shown how to calculate the control voltage for the dc motor; the results of simulation are presented.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Shumiov, V.F. Low Frequency Oscillations Control in the Extended Power Systems with Varying Parameters, Izv. RAN. Energetika, 2003, no. 6, pp. 144–151.
Shumilov, V.F., and Shumilova, N.I., The Ways to Form the Programming Control Voltages Intended for MDP Reactive Forces Compensation by Motors, Promyshlennaya Energetika, 1998, no. 8, pp. 25–27.
Evzerov, I.Kh, Gorobets, A.S., Moshkovich, B.I., and et. al. Komplektnye tiristornye electroprivody: Spravochnik, (Thyristor Drive Engineering Package. Handbook), Moscow: Energoatomizdat, 1988.
Additional information
Original Russian Text © V.F. Shumilov, N.I. Shumilova, 2009, published in Elektrotekhnika, 2009, No. 2, pp. 13–15.
About this article
Cite this article
Shumilov, V.F., Shumilova, N.I. Formation of smooth transient processes during mode switching in automatic electric drives. Russ. Electr. Engin. 80, 72–73 (2009). https://doi.org/10.3103/S1068371209020035
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068371209020035