Abstract
Different designs of metal receivers for casting with melt centrifugation are investigated theoretically and experimentally. It is established that metal receivers of conventional designs with a sharp turn of the flow by 90° do not provide the required mode of filling the mold because of the loss of the initial dynamic force, the sliding of the melt past by the orifices of the collectors, and the appearance of the turbulent flow mode. The configuration of a confusor-type metal receiver, which makes it possible to eliminate the mentioned disadvantages and increase the discharge coefficient to 0.6–0.8, is suggested. The main constructive parameters for this metal receiver are optimized.
Similar content being viewed by others
References
Al’tshul’, A.D., Zhivatovskii, L.S., and Ivanov, L.P., Gidravlika i aerodinamika: Uchebnik dlya vuzov (Hydraulics and Aerodynamics: Textbook for Higher Schools), Moscow: Stroiizdat, 1987.
Konstantinov, L.S., Yui Chuan’-tszin’, Litein. Proizv., 1962, no. 5, p. 5.
Kechin, V.A., Sharshin, V.N., Sukhorukova, E.V., and Sukhorukov, D.V., Liteishchik Rossii, 2007, no. 7, p. 29.
Sharshin, V.N., Kechin, V.A., Sukhorukova, E.V., and Medvedev, A.N., Liteishchik Rossii, 2008, no. 7, p. 50.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © V.N. Sharshin, V.A. Kechin, E.V. Sukhorukova, D.V. Sukhorukov, 2011, published in Izvestiya VUZ. Tsvetnaya Metallurgiya, 2011, No. 3, pp. 19–22.
About this article
Cite this article
Sharshin, V.N., Kechin, V.A., Sukhorukova, E.V. et al. Improvement of configuration of a metal reservoir for casting with centrifugation of the melt. Russ. J. Non-ferrous Metals 52, 223–226 (2011). https://doi.org/10.3103/S1067821211030217
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1067821211030217