Abstract
The effect of simple shear on the structure and properties of metals and alloys subjected to forging is considered. An analysis of the results of the investigation the structure of the material, which was carried out for samples of defined configuration, showed that the treatment of metal under conditions of the development of shear deformations across the workpiece section causes an intense decrease in the grain size.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Naizabekov, A.B., Usloviya razvitiya cdvigovykh deformatsii pri kovke (Conditions of Development of Shear Deformations during Forging), Almaty: Galym, 1997.
Tyurin, V.A., Metallurg, 2000, no. 19, p. 33.
Bogatov, A.A., Mizhiritskii, O.I., and Smirnov, S.V., Resurs plastichnosti metallov pri obrabotke davleniem (Resource of Metal Plasticity under Pressure Treatment), Moscow: Metallurgiya, 1984.
Brun, M.Ya., Shakhanova, G.V., and Ukolova, O.G., Titan, Moscow: VILS, 1995, no. 1–2 (5–6), p. 38.
Polukhin, P.I., Gorelik, S.S., and Vorontsov, V.K., Fizicheskie osnovy plasticheskoi deformatsii. Uchebn. posobie dlya vyssh. uchebn. zaved. (Physical Foundations of Plastic Deformation. Textbook for Colleges), Moscow: Metallurgiya, 1982.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © N.T. Biyakaeva, 2009, published in Izvestiya VUZ. Tsvetnaya Metallurgiya, 2009, No. 6, pp. 56–60.
About this article
Cite this article
Biyakaeva, N.T. Investigation of regularities of variations in the structure of metal under simple shear. Russ. J. Non-ferrous Metals 50, 622–627 (2009). https://doi.org/10.3103/S106782120906011X
Published:
Issue Date:
DOI: https://doi.org/10.3103/S106782120906011X