Advertisement

Russian Engineering Research

, Volume 38, Issue 12, pp 1026–1028 | Cite as

Applicability of Tractional Electric Motors

  • G. A. Pautov
  • V. A. GrechishnikovEmail author
  • O. I. YurasovaEmail author
  • S. Yu. YurasovEmail author
  • E. M. Medvedeva
Article
  • 3 Downloads

Abstract

The practicality of three armature designs for tractional electric motors (power 560–755 kW, tractional force 5326 kgf) is analyzed. The use of an armature shaft of variable (reinforced) cross section in place of the armature with a sleeve is proposed, and suggestions are made regarding the assembly of the bearings. Reinforcement of the working shaft by smoothing may be recommended.

Keywords:

practicality margin of strength microcracks sleeve group interchangeability tractional electric motors armature design 

Notes

REFERENCES

  1. 1.
    Matalin, A.A., Tekhnologiya mashinostroeniya (Technology of Machine Engineering), Moscow: Mashinostroenie, 1985.Google Scholar
  2. 2.
    Odintsov, L.G., Finishnaya obrabotka detalei almaznym vyglazhivaniem i vibrovyglazhivaniem (Finishing of the Parts by Diamond and Vibrational Smoothing), Moscow: Mashinostroenie, 1981.Google Scholar
  3. 3.
    Spravochnik tekhnologa-mashinostroitelya (Handbook of Technologist Machine Engineer), Kosilova, A.G. and Meshcheryakova, R.K., Eds., Moscow: Mashinostroenie, 1986, vol. 1.Google Scholar
  4. 4.
    Grechishnikov, V.A., Petukhov, Yu.E., Pivkin, P.M., et al., Lathe turning of complex-shaped parts providing desired surface microrelief, Russ. Eng. Res., 2016, vol. 36, no. 3, pp. 229–231.CrossRefGoogle Scholar
  5. 5.
    Grechishnikov, V.A., Maslov, A.R., and Pivkin, P.M., Tool system for face grooving using CNC machines, Russ. Eng. Res., 2015, vol. 35, no. 11, pp. 814–817.CrossRefGoogle Scholar
  6. 6.
    Grechishnikov, V.A. and Pivkin, P.M., Face groove machining on the automobile parts, Izv. Mosk. Gos. Tekh. Univ., MAMI, 2014, vol. 2, no. 1, pp. 76–79.Google Scholar
  7. 7.
    Pivkin, P.M., Manufacturing of whole construction of cutter for machining the complex face grooves, Vestn. Mosk. Gos. Tekhnol. Univ., Stankin, 2016, no. 4 (39), pp. 40–46.Google Scholar
  8. 8.
    Grechishnikov, V.A. and Pivkin, P.M., Cutting head for cutting, grooving with a conical generatrix and end grooves on parts of various shape, Vestn. Mosk. Gos. Tekhnol. Univ., Stankin, 2014, no. 2 (29), pp. 50–56.Google Scholar

Copyright information

© Allerton Press, Inc. 2018

Authors and Affiliations

  1. 1.Naberezhnye Chelny Institute, Kazan Federal UniversityKazanRussia
  2. 2.Stankin Moscow State Technical UniversityMoscowRussia

Personalised recommendations