Russian Engineering Research

, Volume 27, Issue 10, pp 715–718

Stress-strain state of the thread-milling tool and blank

  • A. V. Kirichek
  • A. N. Afonin
Article

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

References

  1. 1.
    Lapin, V.V., Pisarevskii, M.I., Samsonov, V.V., and Sizov, Yu.I., Nakatyvanie rez’b, chervyakov, shlitsev i zub’ev (Milling Threads, Worms, Slots, and Gears), Leningrad: Mashinostroenie, 1986.Google Scholar
  2. 2.
    Kuz’menko, A.F., Contact-Stress Distribution in Thread Milling, Avtomobil. Prom., 2004, no. 2, pp. 25–28.Google Scholar
  3. 3.
    Kirichek, A.V. and Afonin, A.N., Prospects for Theoretical Calculation of Plastic Strain in Investigating Thread Milling, Izv. OrelGTU, Mashinostr., Priborostr., 2004, no. 1, pp. 32–33.Google Scholar
  4. 4.
    Kirichek, A.V. and Afonin, A.N., Determining the Diameter of the Blank before Thread Milling by Means of 3D Modeling Systems, Stanki Instrum., 2005, no. 6, pp. 28–30.Google Scholar
  5. 5.
    Bushenin, D.V., Kirichek, A.V., Afonin, A.N., and Kul’kov, I.B., Comparison of the Hardness of Thread Profiles Obtained by Various Methods of Plastic Deformation, Vestn. Mashinostr., 1999, no. 10, pp. 40–43.Google Scholar

Copyright information

© Allerton Press, Inc. 2007

Authors and Affiliations

  • A. V. Kirichek
    • 1
  • A. N. Afonin
    • 1
  1. 1.Kurchatov Institute of Atomic EnergyRussia

Personalised recommendations