Skip to main content

Advertisement

Log in

Petroleum drilling and production operations in the Gulf of Mexico

  • Published:
Estuaries Aims and scope Submit manuscript

Abstract

Decades of offshore and inland petroleum drilling and production in the Gulf of Mexico and on the Gulf coast have provided the much needed energy and chemical feedstocks to the nation, and also have made an impact on the environment in the area. Our study showed deposits of contaminated sediment on the ocean floor around offshore platforms, old reserve pits, and dump sites next to many surface facilities and compressor stations. The substances found on the ocean floor and in dump sites are simple or emulsified mixtures of silt, hydrocarbons, and water. The cleaning of the ocean floor and pits is an economic and technical challenge. Hydrocarbons are from crude oil and chemical additions for various operational necessities, including additions of biocides, corrosion inhibitors, antifreezes, and coagulants. When the new government regulations lower the allowable maximum total organic carbon level to the 50 ppm range, these hydrocarbons can no longer be ignored by drilling and production operators.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

Literature Cited

  • Arnold, K. 1983. Design concepts for offshore produced-water treating and disposal systems.J. Petrol. Technol. 35:276–283.

    Google Scholar 

  • Arnold, K. andM. Stewart. 1986. Surface Production Operations, Vol. 1. Gulf Publishing, Houston, Texas. 414 p.

    Google Scholar 

  • Ayers, R. C., Jr.T. C. Sauer, Jr. andP. W. Anderson. 1985. The generic mud concept for NPDES permitting of offshore drilling discharges.J. Petrol. Technol. 37:475–480.

    CAS  Google Scholar 

  • DiStasio, J. I. 1981. Chemicals for Oil Field Operations, Recent Developments. Noyes Data Corp., Park Ridge, New Jersey. 307 p.

    Google Scholar 

  • EnDean, E. J. 1976. Corrosion control in the well bore.Petrol. Eng. Aug. 1976:50–62.

  • EPA. 1985. Development Document for Proposed Effluent Limitations Guidelines and New Source Performance Standards for the Offshore Subcategory of the Oil and Gas Extraction Point Source Category. EPA 440/1-85/055. Washington, D.C. 408 p.

  • Fang, C. S. andS. A. Smith, Jr. 1986. Cleaning of the ocean floor near off-shore platforms in the Gulf Coast.Energy Prog. 6:37–39.

    CAS  Google Scholar 

  • Gray, G. R., andH. C. H. Darley. 1980. Composition and Properties of Oil Well Drilling Fluids, 4th ed. Gulf Publishing, Houston. 630 p.

    Google Scholar 

  • Hileman, B. 1981. Offshore oil drilling.Environ. Sci. Technol. 15:1259–1263.

    Article  Google Scholar 

  • Kerver, J. K. 1965. Corrosion inhibitor squeeze technique—Field evaluation of engineered squeeze.J. Petrol. Technol. 17:50–57.

    Google Scholar 

  • Menzie, C. A. 1982. The environmental implications of offshore oil and gas activities.Environ. Sci. Technol. 16:454A-472A.

    Article  CAS  Google Scholar 

  • Middleditch, B. S. 1980. Environmental Effects of Offshore Oil Production. Plenum Publishing Corp., New York. 446 p.

    Google Scholar 

  • Narain, S., S. Assad, K. V. D. P. Rao, and M. R. Barakat. 1985. Case histories of corrosion problems in a wastewater treatment plant.Material Sci. 23–27.

  • National Association of Corrosion Engineers. 1979. Corrosion Control in Petroleum Production. NACE/TPC No. 5. Houston, Texas. 84 p.

  • Nesbitt, L. E. andJ. A. Sanders. 1981. Drilling fluid disposal.J. Petrol. Technol. 31:2377–2381.

    Google Scholar 

  • Nikituk, P. M. and V. A. Farris. 1986. OCS National Compendium. OCS Information Report, MMS86-0017. Reston, Virginia. 172 p.

  • Oil and Gas Journal. March 10, 1986. Worldwide crude oil and gas production. p. 80.

  • Oil and Gas Journal. April 13, 1987. Worldwide crude oil and gas production. p. 32.

  • Ostroff, A. G. 1979. Introduction to Oilfield Water Technology. NACE. Houston, Texas. 394 p.

    Google Scholar 

  • Patton, C. C., D. A. Deemer, and H. M. Hilliard, Jr. 1970. Oilwell liquid inhibitor effectiveness.Material Protect. Feb. 1970:37–41.

  • Petrazzuolo, G., A. D. Michael, C. A. Menzie, H. Plugge, E. J. Zimmerman, R. G. Rolan, T. A. Mores, L. A. Smith, W. K. Parland, and S. E. Roth. 1985. Assessment of Environmental Fate of Effects of Discharges from Offshore Oil and Gas Operations. EPA 440/4-85/002. Washington, D.C. 384 p.

  • Risotto, S. P. and J. H. Collins. 1986. Gulf of Mexico Summary Report/Index, Nov. 1984–June 1986. OCS Information Report, MMS86-0084. Reston, Virginia. 102 p.

  • U. S. Dept. of Interior, Mineral Management Service. 1986. Proposed Program, 5-year Outer Continental Shelf Oil and Gas Leasing Program for January 1987–December 1991. Washington, D.C.

  • Williams, B. B., J. L. Gidley, andR. S. Schechter. 1979. Acidizing Fundamentals. Society of Petroleum Engineers, Dallas, Texas. 124 p.

    Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Rights and permissions

Reprints and permissions

About this article

Cite this article

Fang, C.S. Petroleum drilling and production operations in the Gulf of Mexico. Estuaries 13, 89–97 (1990). https://doi.org/10.2307/1351436

Download citation

  • Received:

  • Accepted:

  • Issue Date:

  • DOI: https://doi.org/10.2307/1351436

Keywords

Navigation