Abstract
Flat Steel Ribbon Wound Pressure Vessels (FSRWPVs) are used in many important industry areas. There is no such kind of pressure vessel exploding on operation for its reasonable structure design. Many explosion experiments on Flat Steel Ribbon Wound Pressure Vessel showed that their limited load pressure is related to the winding angle of the steel ribbons. FSRWPVs with reasonable winding angle have better security and lower cost. Reasonable angels given at the end of this paper facilitate engineering design.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
ASME CODE, 1996–1997. Design of Layered Vessels Using Flat Steel Ribbon Wound Cylindrical Shells. ASME Boiler and Pressure Vessel Code, Section VIII, Division 1 and 2, Code Case 2229, 2269.
Huang, P.S., 1992. Stress analysis of pressure vessel with wound flat steel ribbon. ASME Journal of Pressure Vessel Technology, 114:256–259.
Huang, P.S., 1993. Prestress analysis of flat steel ribbon wound vessel. ASME Journal of Pressure Vessel Technology, 115:305–308.
Yu, Z.H., 1999. Strengthened action of frictional force of FSRWPV. Modern Machinery, 2:34–37.
Zheng, J.Y., 1992. Optimal Design of Flat Steel Ribbon Wound Pressure Vessel. Ph.D Thesis, Zhejiang University, China (in Chinese).
Zheng, C.X., 1995. Analysis of Dispersed Structure of Pressure Vessel. Ph.D Thesis, Zhejiang University, China (in Chinese).
Zheng, C.X., 1997. Optimal design of FSRWPV. Petrochemical Machinery, 1:14–17.
Zheng, C.X., 1999. Controllable stress analysis and design of flat steel ribbon wound pressure vessel. Chinese Journal of Mechanical Engineering, 1:33–37.
Zhu, G.H., Wu, H.M., 1993. Engineering Design Specification Proposal of FSRWPV. ASME Proceeding of the Pressure Vessel and Piping Conference, 265:41–47.
Zhu, G.H., Huang, Z.S., 1994. Outstanding developmental advantages of unique ribbon winding techniques for future pressure vessel technology. ASME Pressure Vessel and Piping Conference, 266:112–117.
Zhu, G.H., Zheng, J.Y., 1995. Chinese Steel Ribbon Wound Pressure Vessel. Machinery Industry Publishing House, Beijing, China (in Chinese).
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Zheng, Cx. Research on reasonable winding angle of ribbons of Flat Steel Ribbon Wound Pressure Vessel. J. Zhejiang Univ. - Sci. A 7, 445–449 (2006). https://doi.org/10.1631/jzus.2006.A0445
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1631/jzus.2006.A0445