Abstract
Most automatic steering systems for large tractors are designed with hydraulic systems that run on either constant flow or constant pressure. Such designs are limited in adaptability and applicability. Moreover, their control valves can unload in the neutral position and eventually lead to serious hydraulic leakage over long operation periods. In response to the problems noted above, a multifunctional automatic hydraulic steering circuit is presented. The system design is composed of a 5-way-3- position proportional directional valve, two pilot-controlled check valves, a pressure-compensated directional valve, a pressurecompensated flow regulator valve, a load shuttle valve, and a check valve, among other components. It is adaptable to most open-center systems with constant flow supply and closed-center systems with load feedback. The design maintains the lowest pressure under load feedback and stays at the neutral position during unloading, thus meeting the requirements for steering. The steering controller is based on proportional-integral-derivative (PID) running on a 51-microcontroller-unit master control chip. An experimental platform is developed to establish the basic characteristics of the system subject to stepwise inputs and sinusoidal tracking. Test results show that the system design demonstrates excellent control accuracy, fast response, and negligible leak during long operation periods.
Similar content being viewed by others
References
Âström, K.J., Albertos, P., Quevedo, J., 2001. PID control. Contr. Eng. Pract., 9(11):1159–1161. http://dx.doi.org/10.1016/S0967-0661(01)00061-2
Chen, W.L., Xie, B., Song, Z.H., et al., 2006. Electrohydraulic power steering system for tractors. Trans. Chin. Soc. Agric. Eng., 22(10):122–125 (in Chinese). http://dx.doi.org/10.3321/j.issn:1002-6819.2006.10.026
Dong, Z.L., Zhang, Q., Han, S.F., 2002. Control of an electrohydraulic steering system using a PID controller with a nonlinear compensation algorithm. Proc. SPIE, p.87–95. http://dx.doi.org/10.1117/12.474438
García-Pérez, L., García-Alegre, M.C., Ribeiro, A., et al., 2008. An agent of behaviour architecture for unmanned control of a farming vehicle. Comput. Electron. Agric., 60(1): 39–48. http://dx.doi.org/10.1016/j.compag.2007.06.004
He, Q., Gao, H.W., Li, H.W., et al., 2007. Electrohydraulic steering control system of tractor based on DSP. Trans. Chin. Soc. Agric. Mach., 38(5):1–5 (in Chinese). http://dx.doi.org/10.3969/j.issn.1000-1298.2007.05.001
Inoue, K., Murakami, N., Miyaura, S., 2004. A modeling of a movement of a semi-crawler tractor and an adaptive operational steering control. Proc. Conf. on Automation Technology for Off-Road Equipment, p.348–359. http://dx.doi.org/10.13031/2013.17852
Luo, X.W., Zhang, Z.G., Zhao, Z.X., et al., 2009. Design of DGPS navigation control system for Dongfanghong X- 804 tractor. Trans. Chin. Agric. Eng., 25(11):139–145 (in Chinese). http://dx.doi.org/10.3969/j.issn.1002-6819.2009.11.025
Qiu, H., Zhang, Q., Reid, J.F., 2001. Fuzzy control of electrohydraulic steering systems for agricultural vehicles. Trans. ASAE, 44(6):1397–1402. http://dx.doi.org/10.13031/2013.7005
Reid, J.F., Zhang, Q., Noguchi, N., et al., 2000. Agricultural automatic guidance research in North America. Comput. Electron. Agric., 25(1-2):155–167. http://dx.doi.org/10.1016/S0168-1699(99)00061-7
Shen, W.L., Xue, J.L., Zhang, Y., 2014. Development of electrohydraulic steering system based on agricultural vehicle. J. Hunan Agric. Univ. (Nat. Sci.), 40(3):325–329 (in Chinese). http://dx.doi.org/10.13331/j.cnki.jhau.2014.03.020
Wu, X.P., Zhao, Z.X., Zhang, Z.G., et al., 2009. Development of automatic steering control system based on Dongfanghong tractor. Trans. Chin. Soc. Agric. Mach., 40(Z1): 1–5 (in Chinese).
Zhang, Q., Reid, J.F., Wu, D., 2000. Hardware-in-the-loop simulator of an off-road vehicle electrohydraulic steering system. Trans. ASAE, 43(6):1323–1330. http://dx.doi.org/10.13031/2013.3029
Zhu, Z.X., Chen, J., Yoshida, T., et al., 2007. Path tracking control of autonomous agricultural mobile robots. J. Zhejiang Univ.-Sci. A, 8(10):1596–1603. http://dx.doi.org/10.1631/jzus.2007.A1596
Ziegler, J.G., Nichols, N.B., 1993. Optimum settings for automatic controllers. J. Dyn. Syst. Meas. Contr., 115(2B): 220–222. http://dx.doi.org/10.1115/1.2899060
Author information
Authors and Affiliations
Corresponding author
Additional information
Project supported by the Synergistic Innovation Center of Modern Agricultural Equipment and Technology, China (No. NZXT01201401)
ORCID: Jin-yi LIU, http://orcid.org/0000-0001-7375-9614
Rights and permissions
About this article
Cite this article
Liu, Jy., Tan, Jq., Mao, Er. et al. Proportional directional valve based automatic steering system for tractors. Frontiers Inf Technol Electronic Eng 17, 458–464 (2016). https://doi.org/10.1631/FITEE.1500172
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1631/FITEE.1500172
Keywords
- Automatic steering system
- Hydraulic circuit
- Proportional directional valve
- Proportional-integral-derivative (PID) control