Skip to main content

Impact of mechanical loading on the corrosion of steel reinforcement in concrete structures

Materials and Structures volume 44, pages 1123–1137 (2011)Cite this article

Abstract

This paper presents results of an experimental investigation on the effect of mechanical loading on the corrosion of steel reinforcement in concrete. Reinforced concrete beams were cast, subjected to mechanical loadings and then exposed to corrosive environment. Successive drying and wetting cycles using 3% sodium chloride salt solution were used to accelerate the corrosion attack. Electrochemical techniques such as macrocell corrosion current, linear polarization resistance (LPR), corrosion potential (E corr ) and electrochemical impedance spectroscopic (EIS), were used to evaluate the corrosion behavior of the reinforcement. Also, chloride penetration profile and visual inspection of the beam rebars were obtained. The results shows that the pre-exposure mechanical load has no influence on the corrosion initiation or corrosion rate thereafter, unless it reaches to some limit where it develops connected cracks through which the chloride ions flow and depassivate the rebars. The load of 25% of the ultimate capacity seems to be the critical load limit where some microcracks onset to be connected, facilitate the chloride ions flow, and initiate the rebar corrosion.

This is a preview of subscription content, access via your institution.

Access options

Buy single article

Instant access to the full article PDF.

39,95 €

Price includes VAT (Finland)

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Fig. 16
Fig. 17
Fig. 18
Fig. 19

References

  1. Cabrera JG (1996) Deterioration of concrete due to reinforcement steel corrosion. Cem Concr Compos 18(1):47–59

    Article  Google Scholar 

  2. Huang R, Yang CC (1997) Condition assessment of reinforced concrete beams relative to reinforcement corrosion. Cem Concr Compos 19(2):131–137

    Article  Google Scholar 

  3. Sherwood EG, Soudki KA (2000) Rehabilitation of corrosion damaged concrete beams with CFRP laminates—a pilot study. Compos B Eng 31(6–7):453–459

    Article  Google Scholar 

  4. Fang C, Gylltoft K, Lundgren K, Plos M (2006) Effect of corrosion on bond in reinforced concrete under cyclic loading. Cem Concr Res 36(3):548–555

    Article  Google Scholar 

  5. Mangat PS, Elgarf MS (1999) Strength and serviciability of repaired reinforced concrete beams undergoing reinforcement corrosion. Mag Concr Res 51(2):97–112

    Article  Google Scholar 

  6. Castel A, Francois R, Arliguie G (2006) Mechanical behaviour of corroded reinforced concrete beams—Part 1: experimental study of corroded beams. Mater Struct 33(9):539–544

    Article  Google Scholar 

  7. Bentur A, Diamond S, Berke NS (1997) Steel corrosion in concrete, 1st edn. E & FN Spon, London

    Google Scholar 

  8. Li CQ (2000) Corrosion initiation of reinforcing steel in concrete under natural slat spry and service loading—results and analysis. ACI Mater J 97(6):690–697

    Google Scholar 

  9. Jacobsen S, Marchand J, Gerard B (1998) Concrete cracks I: durability and self healing—a review. In: Gjorv OE, Sakai K, Banthia N (eds) The second international conference on concrete under severe conditions. E & FN Spon, Tromso, pp 217–231

  10. Francois R, Arliguie G, Castel A (1998) Influence of service cracking on service life of reinforced concrete. In: Gjorv OE, Sakai K, Banthia N (eds) The second international conference on concrete under severe conditions. E & FN Spon, Tromso, pp 143–152

  11. Castel A, Francois R, Arliguie G (1999) Effect of loading on carbonation penetration in reinforced concrete elements. Cem Concr Res 29(4):561–565

    Article  Google Scholar 

  12. Francois R, Maso JC (1988) Effect of damage in reinforced concrete on carbonation or chloride penetration. Cem Concr Res 18(6):961–970

    Article  Google Scholar 

  13. Yoon S, Wang K, Weiss WJ, Shah SP (2000) Interaction between loading, corrosion, and serviceability of reinforced concrete. ACI Mater J 97(6):637–644

    Google Scholar 

  14. Kondratova IL, Montes P, Bremner TW (2003) Natural marine exposure results for reinforced concrete slabs with corrosion inhibitors. Cem Concr Compos 25(4–5):483–490

    Article  Google Scholar 

  15. Ersoy U, Ozcebe G, Tankut T (2003) Reinforced concrete, 2nd edn. Middle East Technical University, Ankara

    Google Scholar 

  16. Jones DA (1996) Principles and prevention of corrosion, 2nd edn. Prentice-Hall, Inc., Upper Saddle River

    Google Scholar 

  17. Bertolini L, Elsense B, Pedeferri P, Polder R (2004) Corrosion of steel in concrete: prevention, diagnosis, repair. Wiley-VCH Verlag GmbH & Co. KGaA, Weinheim

    Google Scholar 

  18. Ababneh A (2002) The coupled effect of moisture diffusion chloride penetration and freezing-thawing on concrete durability. PhD Dissertation, University of Colorado

  19. Gonzalez JA, Andrade C (1982) Effect of carbonation, chloride and relative ambient humidity on the corrosion of galvanized rebars embedded in concrete. Br Corros J 17(1):21–28

    Google Scholar 

  20. Morris W, Vazquez M, De Sanchez SR (2000) Efficiency of coatings applied on rebars in concrete. J Mater Sci 35:1885–1890

    Article  Google Scholar 

  21. Darwin D, Browning JP, Nguyen T, Locke CE (2002) Mechanical and corrosion properties of a high-strength, high chromium reinforcing steel for concrete. Rep. No. SD2001-05-F. South Dakota Department of Transportation Office of Research, Federal Highway Administration, U.S. Department of Transportation, Lawrence

  22. Dhouibi L, Triki E, Raharinaivo A, Trabanelli G, Zucchi F (2000) Electrochemical methods for evaluating inhibitors of steel corrosion in concrete. Br Corros J 35(2):145–149

    Article  Google Scholar 

  23. Kendig M, Scully JR (1990) Basic aspects of electrochemical impedance application for the life prediction of organic coating on metals. Corrosion 46(1):22–29

    Article  Google Scholar 

  24. Monticelli C, Frignani A, Trabanelli G (2002) Corrosion inhibition of steel in chloride-containing alkaline solutions. J Appl Electrochem 32(5):527–535

    Article  Google Scholar 

  25. Montemor MF, Simoes AMP, Salta MM (2000) Effect of fly ash on concrete reinforcement corrosion studied by EIS. Cem Concr Compos 22:175–185

    Article  Google Scholar 

  26. Hachani L, Carpio J, Fiaud C, Raharinaivo A, Triki E (1992) Steel corrosion in concrete deteriorated by chlorides and sulphates: electrochemical study using impedance spectrometry and “stepping down the current” method. Cem Concr Res 22:56–66

    Article  Google Scholar 

  27. Jianguo L, Gaoping G, Chuanwei Y (2005) EIS study of corrosion behaviour of organic coating/Dacromet composite systems. Electrochim Acta 50(16–17):3320–3332

    Article  Google Scholar 

  28. Buchheit RG, Cunningham M, Jensen H, Kendig M, Martinez MA (1998) A correlation between salt spray and electrochemical impedance spectroscopy test results for conversion-coated aluminum alloys. Corrosion 54(1):61–72

    Article  Google Scholar 

  29. Chen H, Wheat HG (1996) Evaluation of selected epoxy-coated reinforcing. In: Corrosion 96, the NACE international annual conference and exposition

  30. Hearn N (1999) Effect of shrinkage and load-induced cracking on water permeability of concrete. ACI Mater J 96(2):234–241

    Google Scholar 

  31. Samaha H, Hover KC (1992) Influence of microcracking on the mass transport properties of concrete. ACI Mater J 89(4):416–424

    Google Scholar 

  32. Yang Z, Weiss WJ, Olek J (2006) Water transport in concrete damaged by tensile loading and freeze-thaw cycling. Construct Build Mater 18(3):424–434

    Google Scholar 

  33. Benjamin MM, Sontheimer H, Leroy P (1996) Corrosion of iron and steel. In: Internal corrosion of water distribution systems. American Water Works Association Research Foundation and DVGW, Denver, pp 29–70

Download references

Author information

Authors and Affiliations

  1. Department of Civil Engineering, Jordan University of Science and Technology, P.O. Box 3030, Irbid, 22110, Jordan

    Ayman Ababneh

  2. Department of Civil Engineering, Hadramout University of Science and Technology, P.O. Box 50512-50511, Mukalla, Yemen

    Mashal Sheban

Authors
  1. Ayman Ababneh
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Mashal Sheban
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Ayman Ababneh.

Rights and permissions

Reprints and Permissions

About this article

Cite this article

Ababneh, A., Sheban, M. Impact of mechanical loading on the corrosion of steel reinforcement in concrete structures. Mater Struct 44, 1123–1137 (2011). https://doi.org/10.1617/s11527-010-9688-3

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1617/s11527-010-9688-3

Keywords

  • Loading
  • Corrosion
  • Steel
  • LPR
  • EIS
  • Concrete