Abstract
Ordinary portland cement (OPC) has been traditionally used as the binding agent in concrete. However, it is also necessary to search for alternative low-emission binding agents for concrete to reduce the environmental impact caused by manufacturing of cement. Geopolymer, also known as inorganic polymer, is one such material that uses by-product material such as fly ash instead of cement. Recent research has shown that fly ash-based geopolymer concrete has suitable properties for its use as a construction material. Since the strength development mechanism of geopolymer is different from that of OPC binder, it is necessary to obtain a suitable constitutive model for geopolymer concrete to predict the load–deflection behaviour and strength of geopolymer concrete structural members. This article has investigated the suitability of using an existing stress–strain model originally proposed by Popovics for OPC concrete. It is found that the equation of Popovics can be used for geopolymer concrete with minor modification to the expression for the curve fitting factor, to better fit with the post-peak parts of the experimental stress–strain curves. The slightly modified set of stress–strain equations was then used in a non-linear analysis for reinforced concrete columns. A good correlation is achieved between the predicted and measured ultimate loads, load–deflection curves and deflected shapes for 12 slender test columns.
Similar content being viewed by others
References
Mehta PK (2001) Reducing the environmental impact of concrete. Concr Int 23(10):61–66
Davidovits J (1994) High-alkali cements for 21st century concretes. Concrete technology past, present and future. ACI Special Publication, SP 144. Farmington Hills, Michigan, pp 383–398
Hardjito D, Wallah SE, Sumajouw DMJ et al (2004) On the development of fly ash-based geopolymer concrete. ACI Mater J 101(6):467–472
Hardjito D, Wallah SE, Sumajouw DMJ et al (2005) Fly ash-based geopolymer concrete. Aust J Struct Eng 6(1):77–86
Rangan BV (2006) Studies on low-calcium fly ash-based geopolymer concrete. Indian Concr Inst J October–December:9–17
Sarker PK (2004) Making geopolymer concrete using Sarawak fly ash. In: Proceedings of the first international conference of Asian Concrete Federation, Chiang Mai, Thailand, 28–29 October 2004, pp 633–640
Sarker PK, Grigg A, Chang EH (2007) Bond strength of geopolymer concrete with reinforcing steel. In: Zingoni A (ed) Recent developments in structural engineering, mechanics and computation, CD ROM. Mill press, The Netherlands, pp 1315–1320
Sarker PK, deMeillon T (2007) Residual strength of geopolymer concrete after exposure to high temperature. In: Zingoni A (ed) Recent developments in structural engineering, mechanics and computation, CD ROM. Mill press, The Netherlands, pp 1566–1571
Sumajouw DMJ, Hardjito D, Wallah SE et al (2007) Fly ash-based geopolymer concrete: study of slender columns. J Mater Sci 42(9):3124–3130. doi:10.1007/s10853-006-0523-8
Fernandez-Jimenez AM, Palomo A, Lopez-Hombrados C (2006) Engineering properties of alkali-activated fly ash concrete. ACI Mater J 103(2):106–112
Sofi M, van Deventer JSJ, Mendis PA et al (2007) Engineering properties of inorganic polymer concretes (IPCs). Cement Concr Res 37:251–257. doi:10.1016/j.cemconres.2006.10.008
Sofi M, van Deventer JSJ, Mendis PA et al (2007) Bond performance of reinforcing bars in inorganic polymer concretes (IPCs). J Mater Sci 42:3107–3116. doi:10.1007/s10853-006-0534-5
Hardjito D, Rangan BV (2005) Development and properties of low calcium fly ash-based geopolymer concrete. Research Report GC1, Faculty of Engineering, Curtin University of Technology, Western Australia. Available via http://espace.lis.curtin.edu.au/
Hardjito D, Wallah SE, Sumajouw MJ et al (2005) The stress–strain behaviour of fly ash-based geopolymer concrete. In: Developments in mechanics of structures and materials. A A Balkema Publishers, The Netherlands, pp 831–834
Popovics S (1973) A numerical approach to the complete stress–strain curve of concrete. Cement Concr Res 3:583–599. doi:10.1016/0008-8846(73)90096-3
Sarker PK, Rangan BV (2003) Reinforced concrete columns under unequal load eccentricities. ACI Struct J 100(4):519–528
AS 1012.17 (1997) Determination of static chord modulus of elasticity and poisson’s ratio of concrete specimens. Standards Association of Australia, Sydney, Australia
ACI Committee 363 (1993) State of the art of high strength concrete. American Concrete Institute, Detroit, USA
AS 3600 (2001) Concrete structures. Standards Association of Australia, Sydney, Australia
Carrasquillo RL, Nilson AS, Slate FO (1981) Properties of high strength concrete subjected to short term loads. ACI J 78:171–178
Ahmad SH, Shah SP (1985) Structural properties of high strength concrete and its implication for precast pre-stressed concrete. PCI J 30:92–119
Thorenfeldt E, Tomaszewicz A, Jensen JJ (1987) Mechanical properties of high strength concrete and application in design. In: Proceedings of the symposium of on utilization of high strength Concrete. Tapir, Trondheim, 1987, pp 149–159
Collins MP, Mitchell D (1991) Prestressed concrete structures. Prentice-Hall Inc., Englewood Cliffs, NJ
Collins MP, Mitchell D, MacGregor JG (1993) Structural design considerations for high-strength concrete. Concr Int 15(5):27–34
ACI Committee 363 (1984) State of the art report on high strength concrete. ACI Proc 81(4):364–411
Ibrahim HHH, MacGregor JG (1997) Modification of the ACI rectangular stress block for high-strength concrete. ACI Struct J 94(1):40–48
MacGregor JG, Wight JK (2006) Reinforced concrete mechanics and design, 4th edn. In SI units. Prentice Hall, Singapore
Pfrang EO, Siess CP, Sozen MA (1964) Load–moment–curvature characteristics of reinforced concrete cross-sections. ACI J Proc 61(7):763–777
Warner RF, Rangan BV, Hall AS et al (1998) Concrete structures. Addison Wesley Longman, Australia
Kilpatrick AE (1996) The behaviour of high strength composite concrete columns. PhD Thesis, Curtin University of Technology, Western Australia
Sarker PK (2001) Study of high strength concrete columns. PhD Thesis, Curtin University of Technology, Western Australia
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Sarker, P.K. Analysis of geopolymer concrete columns. Mater Struct 42, 715–724 (2009). https://doi.org/10.1617/s11527-008-9415-5
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1617/s11527-008-9415-5