Skip to main content
Log in

Structure Evolution of Thermotropic Polymers by Thermal Annealing. A Light and X-Ray Scattering Study

  • Published:
MRS Online Proceedings Library Aims and scope

Abstract

Small-angle light scattering (SALS) and wide-angle X-ray scattering (WAXS) were used to study the influence of heat treatment on the texture and microstructure of extruded films of high-performance thermotropic liquid crystal polymers (LCPs). The microstructure was correlated with tensile mechanical properties. LCPs based on random units of hydroxybenzoic acid (B), hydroxynaphthoic acid (N), terephthalic acid (TA) and biphenol (BP) were supplied by the former Hoechst Celanese Corp. as 50 μm thick extruded films. The LCPs, denoted B-N, COTBP and RD1000, have B and N as common co-monomers and vary the other co-monomers. Thus, this study also enabled the investigation of the influence of monomer composition on microstructure and mechanical properties. Heat treatments were carried out at temperatures close to the solid-to-nematic transition (Ts→n) for periods up to 5 h, under dry air conditions. The thermal treatment produced either two endotherms or a small increase of Ts→n (B-N and RD1000), or Ts→n increased significantly (COTBP). Moreover, when heat treatment was carried out approximately 40°C below the respective Ts→n, the mechanical Young’s modulus, E, along the extrusion axis increased for all LCPs. Strikingly, for COTBP, E increased over 100% relative to the as-extruded film. The results also showed that the optimum treatment time for improving the Young modulus was between 3 and 4 h. Wide-angle X-ray scattering showed a significant sharpening of crystalline reflections and concentration of the 002 meridional reflection as a result of thermal treatment, suggesting the elimination of defects and a better alignment of the molecular chains along the extrusion axis. This would explain the increase in tensile modulus.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

References

  1. G.W. Calundann and M Jaffe, in Synthetic Polymers, (Proc. Robert A. Welch Conf. Chem. Res. XXVI, Welch Foundation, Houston, 1982), p. 247.

    Google Scholar 

  2. W.J. Jackson and H.F. Kuhfuss, J. Polym. Sci. Polym. Chem. 14, 2043 (1976).

    Article  CAS  Google Scholar 

  3. A.M. Donald, A.H. Windle and S Hanna, Liquid Crystalline Polymers, 2nd ed. (Cambridge University Press, U.K., 2005).

    Google Scholar 

  4. M.G. Dobb, D.J. Johnson and B.P. Saville, Polymer. 22, 960 (1987).

    Article  Google Scholar 

  5. T.S. Chung, Polym. Eng. Sci. 26, 901 (1986).

    Article  CAS  Google Scholar 

  6. S.Z.D. Cheng, Macromolecules 21, 2475 (1988).

    Article  CAS  Google Scholar 

  7. S. Salahshoor-Kordestani, S. Hanna and A.H. Windle, Polymer. 41, 6619 (2000).

    Article  CAS  Google Scholar 

  8. A. Romo-Uribe, B. Alvarado-Tenorio and M.E. Romero-Guzmán, Rev. LatinAm. Metal. Mat. 30, 190 (2010).

    Google Scholar 

  9. S.Z.D. Cheng, J.J. Janimak, A. Zhang and Z. Zhou, Macromolecules 22, 4240 (1989).

    Article  CAS  Google Scholar 

  10. A. Romo-Uribe, T.J. Lemmon and A.H. Windle, J. Rheol. 41, 1117 (1997).

    Article  CAS  Google Scholar 

  11. A. Reyes-Mayer, B. Alvarado-Tenorio, A. Romo-Uribe and M. Jaffe, Polym. Adv. Techn. 24, 1029 (2013).

    Article  CAS  Google Scholar 

  12. A. Reyes-Mayer, A. Romo-Uribe, B. Alvarado-Tenorio and M. Jaffe, Polym. Mater.: Sci. Eng. 109, (2013).

  13. A. Reyes-Mayer, A. Constant, A. Romo-Uribe and M Jaffe, in Advanced Structural Materials-2012, edited by H. Calderon, H.A. Balmori and A. Salinas (Mater. Res. Soc. Symp. Proc. 1485, Pittsburgh, PA, 2013).

  14. G.D. Butzbach, J.H. Wendorff and H.J. Zimemerman, Polymer. 27, 1337 (1986).

    Article  CAS  Google Scholar 

  15. C.K. Saw, G. Collins, L. Menczel and M. Jaffe, in Selected Papers, edited by M. LaTorre (Proc. 35th Annual Conference of NATAS, Louisville, KY, 2008).

  16. L.E. Alexander, X-Ray Diffraction Methods in Polymer Science, (John Wiley and Sons, London, 1969).

    Google Scholar 

Download references

Acknowledgments

A. Reyes-Mayer acknowledges the financial support of the Mexican Council for Science and Technology, CONACyT, for a graduate scholarship. Thanks to Hoechst Celanese Corp (Summit, NJ, USA) for providing extruded LCP tapes. This research was supported by CONACYT, under the program Ciencia Básica CB2011, grant 168095.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Angel Romo-Uribe.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Reyes-Mayer, A., Romo-Uribe, A. & Jaffe, M. Structure Evolution of Thermotropic Polymers by Thermal Annealing. A Light and X-Ray Scattering Study. MRS Online Proceedings Library 1765, 65–70 (2015). https://doi.org/10.1557/opl.2015.808

Download citation

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1557/opl.2015.808

Navigation