Electrospinning 3D Scaffolds for use in Neural Tissue Engineering

Abstract

Polymer nanofiber scaffolds for use in neural tissue engineering have been fabricated via electrospinning of poly-L-lactic acid (PLLA) directly onto a 3D printed support. Previously, the investigators have shown success in promoting the directed growth of neural axons on highly aligned PLLA substrates bothin vitro andin vivo. However, one criticism of the earlierin vitro studies is that by spinning fibers on a flat, two-dimensional surface, the growth of the axons is restricted to one plane. Thus the axon-to-fiber attachment may not be the sole mechanism for aligning the growth of the axons along the fibers, and the channels between the fibers and the substrate could contribute to the results. Using 3D-printing, elevated or “bridge” spinning stages were made with supports at varying heights, allowing the fibers to be suspended 2 to 5 mm above the substrate surface in different configurations. This 3D structure promotes better access ofin vitro cell cultures on the fibers to the growth media during incubation, reduces substrate effects, allows more degrees of freedom for axonal growth, and more closely simulates the growth environment foundin vivo. Using these 3D stages, we have electrospun free-standing, highly-aligned pure PLLA fiber scaffolds. We are exploring spinning coaxial fibers with a PLLA sheath and a second core polymer. These coaxial fiber scaffold structures offer additional opportunities forin situ delivery of growth agents and/or electrical stimulation for improved axonal growth results.