Skip to main content
SpringerLink
Log in

Nanostructured Nb-substituted CaMnO3 n-type thermoelectric material prepared in a continuous process by ultrasonic spray combustion

  • Published:
Journal of Materials Research Aims and scope Submit manuscript

Abstract

One way to further optimize the thermoelectric properties toward a higher ZT is a temperature stable nanoengineering of materials, where the thermal conductivity is reduced by increasing the phonon scattering at the grain boundaries. To study this, Nb-substituted CaMnO3 perovskite-type material was synthesized by ultrasonic spray combustion (USC). The grain growth has been characterized by x-ray diffraction, scanning electron microscopy, and transmission electron microscopy. Finally, the thermoelectric properties of compacted and sintered bulk samples from powder prepared by a continuous scalable USC process were measured up to 1050 K. The thermoelectric legs were prepared by an adapted sintering process. Here, a compromise between enhanced porosity to reduce the thermal conductivity and securing of mechanical stability and low resistivity should be obtained. Based on the grain growth mechanisms, an advanced sintering process for additional interconnection of the particles without particle growth is needed to further increase the thermoelectric performance.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

TABLE I.
TABLE II.
FIG. 1.
FIG. 2.
FIG. 3.
FIG. 4.
FIG. 5.
FIG. 6.
FIG. 7.
FIG. 8.
FIG. 9.
FIG. 10.
FIG. 11.
FIG. 12.
FIG. 13.

Similar content being viewed by others

REFERENCES

  1. S.S. Kim, F. Yin, and Y. Kagawa: Thermoelectricity for crystallographic anisotropy controlled Bi–Te based alloys and p–n modules. J. Alloy. Comp. 419, 306 (2006).

    Article  CAS  Google Scholar 

  2. P. Pichanusakorn and P. Bandaru: Nanostructured thermoelectrics. Mater. Sci. Eng., R 67, 19 (2010).

    Article  Google Scholar 

  3. A. Weidenkaff: Preparation and application of nanostructured perovskite phases. Adv. Eng. Mater. 6, 709 (2004).

    Article  CAS  Google Scholar 

  4. E. Krupicka, A. Reller, and A. Weidenkaff: Morphology of nanoscaled LaMO3-particles (M=Mn, Fe, Co, Ni) derived by citrate precursors in aqueous and alcoholic solvents. Cryst. Eng. 5, 195 (2002).

    Article  CAS  Google Scholar 

  5. L. Bocher, R. Robert, M.H. Aguirre, S. Malo, S. Hébert, A. Maignan, and A. Weidenkaff: Thermoelectric and magnetic properties of perovskite-type manganate phases synthesised by a ultrasonic spray combustion (USC). J. Sol. State Sci. 10, 496 (2008).

    Article  CAS  Google Scholar 

  6. A.L. Patterson: The Scherrer formula for x-ray particle size determination. Phys. Rev. 56, 978 (1939).

    Article  CAS  Google Scholar 

  7. J. Blumm: Thermophysical properties characterization of zirconia prior to, during and after the sintering process. CFI-Ceram. Forum Int. 82, E32 (2005).

    CAS  Google Scholar 

  8. L. Bocher, M.H. Aguirre, R. Robert, D. Logvinovich, S. Bakardjieva, J. Hejtmanek, and A. Weidenkaff: High-temperature stability, structure and thermoelectric properties of CaMn1-xNbxO3 phases. Acta Mater. 57, 5667 (2009).

    Article  CAS  Google Scholar 

  9. L. Bocher, M.H. Aguirre, D. Logvinovich, A. Shkabko, M. Trottmann, and A. Weidenkaff: CaMnxNb1-xO3 perovskite-type phases as promising new high temperature thermoelectric materials. Inorg. Chem. 47, 8077 (2008).

    Article  CAS  Google Scholar 

  10. P. Tomeš, M. Trottmann, C. Suter, M.H. Aguirre, A. Steinfeld, P. Haueter, and A. Weidenkaff: Thermoelectric oxide modules (TOMs) for the direct conversion of simulated solar radiation into electrical energy. Materials 3, 2801 (2010).

    Article  Google Scholar 

  11. X. Song, M. Xie, F. Zhou, G. Jia, X. Hao, and S. An: High-temperature thermal properties of yttria fully stabilized zirconia ceramics. J. Rare Earths 29, 155 (2011).

    Article  CAS  Google Scholar 

  12. K.W. Schlichting, N.P. Padture, and P.G. Klemens: Thermal conductivity of dense and porous yttria-stabilized zirconia. J. Mater. Sci. 36, 3003 (2001).

    Article  CAS  Google Scholar 

Download references

ACKNOWLEDGMENTS

The authors acknowledge Nico Studer for the great work on the USC, Songhak Yoon for help in the XRD measurements, Oliver Brunko for the help in sample preparation, Ye Lu for the BET experiments, Lassi Karvonen for help and discussion about the heat treatment of the samples, and finally Petr Tomeš for help with the data treatment.

Author information

Authors and Affiliations

  1. Solid State Chemistry and Catalysis, Empa, Swiss Federal Laboratories for Materials Testing and Research, CH-8600, Duebendorf, Switzerland

    Sascha Populoh, Matthias Trottmann, Myriam H. Aguire & Anke Weidenkaff

Authors
  1. Sascha Populoh
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Matthias Trottmann
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. Myriam H. Aguire
    View author publications

    You can also search for this author in PubMed Google Scholar

  4. Anke Weidenkaff
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Anke Weidenkaff.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Populoh, S., Trottmann, M., Aguire, M.H. et al. Nanostructured Nb-substituted CaMnO3 n-type thermoelectric material prepared in a continuous process by ultrasonic spray combustion. Journal of Materials Research 26, 1947–1952 (2011). https://doi.org/10.1557/jmr.2011.140

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1557/jmr.2011.140

Search

Navigation