This is a preview of subscription content, log in via an institution to check access.
References
E.W. Fawcett, R.O. Gibson, M.W. Perrin, J.G. Patten, and E.G. Williams, British Pattern 471 (1934) p. 590.
C.W. Bunn, “The Crystallographic Unit Cell of Polyethylene,” Trans. Faraday Soc. 35 (1939) p. 482.
A. Keller, “Polymer Crystals,” Rep. Prog. Phys. 31 (2) (1968) p. 623.
A.J. Pennings, J.M.A.A. Van der Mark, and A.M. Keil, “Hydrodynamically Included Crystallization of Polymers From Solution,” Kolloid. Z.Z. Polym. 237 (1970) p. 336.
F.C. Frank, “The Strength and Stiffness of Polymers,” Proc. R. Soc. London, Ser. A. 319 (1970) p. 127.
A. Zwijnenburg and A.J. Pennings, “Longi¬tudinal Growth of Crystals From Flowing So¬lutions II,” Colloid Polym. Sci. 253 (1975) p. 452.
Ibid., “Longitudinal Growth of Crystals From Flowing Solutions III,” ibid. 254 (1976) p. 868.
P. Smith and P.J. Lemstra, “Ultra Drawing of High Molecular Weight Polyethylene Cast From Solution,” J. Mater. Sci. 15 (1980) p. 505.
I.M. Ward, “The Preparation, Structure and Properties of Ultra High Modulus Flexible Polymers,” Adv. Polym. Sci. 70 (1985) p. 1.
Rights and permissions
About this article
Cite this article
Mackley, M. The Scientific and Technological Route to the Manufacture of High-Modulus Polyethylene. MRS Bulletin 22, 47–50 (1997). https://doi.org/10.1557/S088376940003400X
Published:
Issue Date:
DOI: https://doi.org/10.1557/S088376940003400X