Abstract
In this paper we present results concerning the influence of laser energy and shot density on the electrical resistance, X-ray diffraction pattern, and structure obtained by SEM, on recrystallized a-Si:H thin films produced by using a Nd-YAG laser, working in a wavelength of 532 nm. The base material (undoped and doped a-Si:H) was obtained by Plasma Enhanced Chemical Vapour Deposition (PECVD). The structure and electrical characteristics of the recrystallized thin films are dependent on the laser beam energy density, beam spot size and the number of shots applied to the base a-Si:H thin film used. Overall, the data show recrystallized material with grain sizes larger than lµm, where the electrical resistance of both, undoped and doped materials, can be varied up to 5 orders of magnitude, by the proper choice of the recrystallization conditions.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
R. I. Johnson, G. B. Anderson, J. B. Boyce, D. K. Fork, P. Mei, S. E. Ready, and S. Chen, “Critical Laser Fluence Observed in (111) Texture, Grain Size and Mobility of Laser Crystallized Amorphous Silicon”, Mat. Res. Soc. Symp. Proc., vol.297, p.533 (1993).
C. Summonte, M. Bianconi and D. Govoni, “Excimer Laser Amorphous Silicon Film Crystallization: a Study of Time Resolved Reflectivity measurements”, Mat. Res. Soc. Symp. Proc., vol.297, p.539 (1993).
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Carvalho, J., Ferreira, I., Fernandes, B. et al. Nd-YAG Laser Induced Crystallization on a-Si∶H Thin Films. MRS Online Proceedings Library 358, 915 (1994). https://doi.org/10.1557/PROC-358-915
Published:
DOI: https://doi.org/10.1557/PROC-358-915