Abstract
Zinc oxide (ZnO) films were prepared by a nearby vaporizing chemical vapor deposition method using bis(2,4-pentanedionato)zinc as a source material. The deposition rate increased exponentially from 0.58 to 147 nm min−1 with increasing substrate temperature (Ts). The highest preferred orientation to the c axis was obtained under the conditions that the distance between substrate and source surface was 5.0 mm, and the Ts was 300 °C. When we used a sapphire (0001) substrate, an epitaxial ZnO film could be deposited on this condition.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
M. Kawasaki, A. Ohtomo, I. Ohkubo, H. Koinuma, Z.K. Tang, P. Yu, G.K.L. Wong, B.P. Zhang, and Y. Segawa, Mater. Sci. Eng. B 56, 239 (1998).
P. Souletie and B.W. Wessels, J. Mater. Res. 3, 740 (1988).
A.P. Roth and D.F. Williams, J. Appl. Phys. 52, 6685 (1981).
A.P.Roth and D.F. Williams, J. Electrochem. Soc. 128, 2684 (1981).
W.W. Wenas, A. Yamada, M. Konagai, and K. Takahashi, Jpn. J. Appl. Phys. 30(3B), L441 (1991).
Zhuxi Fu, Bixia Lin, and Jie Zu, Thin Solid Films 402, 302 (2002).
K. Kamata, J. Nishino, S. Ohshio, K. Maruyama, and M. Ohtuki, J. Am. Ceram. Soc. 77, 505 (1994).
G. Rudolph and M.C. Henry, Inorg. Synth. X, 74 (1967).
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Nishino, J., Nosaka, Y. Preparation of ZnO by a nearby vaporizing chemical vapor deposition method. Journal of Materials Research 18, 2029–2032 (2003). https://doi.org/10.1557/JMR.2003.0285
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1557/JMR.2003.0285