Abstract
Effects of thermal cycling in a reducing (deuterium) atmosphere on the structure and chemistry of Cr/Cu/Cr/polyimide (PI)/Si and Au/Cu/Ti/polyimide (PI)/Si multilayer systems have been studied. In the Cr/PI system the interface between the Cr and PI was sharp and distinct in the as-deposited state, and after the anneal in the reducing atmosphere. Tensile cracks through the Cr/Cu/Cr layers were found after annealing and are the result of thermal stresses. No evidence for significant diffusion of Cr into the PI was found. In the Ti/PI system, the interface between the Ti and PI was sharp in the as-deposited state. After annealing in vacuum and in the reducing environment, regions of the interface between the Ti layer and the PI were converted to an oxide, Ti5O9. Annealing in the deuterium environment also caused delamination of the Ti film from the PI and blistering of the metal in the sample interior. No significant diffusion of the Ti into the PI was detected. In both systems, the metal in contact with the PI acted as a barrier to the diffusion of Cu into the PI.
Similar content being viewed by others
References
P. S. Ho, R. Haight, R. C. White, and B. D. Silverman, J. de Physique C5, 49 (1988).
M. J. Goldberg, J. C. Clabes, A. Viehbeck, and C. A. Kovac, in Electronic Packaging Materials Science, edited by E. A. Giess, K-N. Tu, and D. R. Uhlmann (Mater. Res. Soc. Symp. Proc. 40, Pittsburgh, PA, 1985), p. 225.
P. O. Hahn, G. W. Rubloff, J. W. Bartha, F. LeGoues, R. Tromp, and P. S. Ho, in Electronic Packaging Materials Science, edited by E. A. Giess, K-N. Tu, and D. R, Uhlmann (Mater. Res. Soc. Symp. Proc. 40, Pittsburgh, PA, 1985), p. 251.
S. G. Anderson, H. M. Mayer, and J. H. Weaver, J. Vac. Sci. Technol. A 6 (4), 2205 (1988).
R. Haight, R. C. White, B. D. Silverman, and P. S. Ho, J. Vac. Sci. Technol. A 6 (4), 2188 (1988).
F. S. Ohuchi and F. S. Freilich, J. Vac. Sci. Technol. A 4 (3), 1036 (1986).
P. Bodo and J-E. Sundgren, J. Vac. Sci. Technol. A 6 (4), 2396 (1988).
F. K. LeGoues, B. D. Silverman, and P. S. Ho, J. Vac. Sci. Technol. A 6 (4), 2200 (1988).
S. Rao Peddada, Ph. D. Thesis, University of Illinois (1991).
Polyimide–Synthesis, Characterization and Applications, edited by K. L. Mittal (Plenum Press, New York, 1984), Vol. 1.
B. K. Fumam, S. Purshottaman, E. Castellani, and S. Renick, Proc. Symp. Multilevel Metallization (Electro. Chem. Soc. Annual Meeting, San Diego, CA, 1986).
K. Sengupta, Ph. D. Thesis, University of Illinois (1991).
D. R. Gaskell, Introduction to Metallurgical Thermodynamics, 2nd ed. (McGraw-Hill, New York, 1981).
K. Seshan, R. H. Lacombe, and J. B. Wagner, Jr., in Thin Films: Stresses and Mechanical Properties, edited by J. C. Bravman, W. D. Nix, D. M. Barnett, and D. A. Smith (Mater. Res. Soc. Symp. Proc. 130, Pittsburgh, PA, 1989), p. 367.
R. M. Jones, Mechanics of Composite Materials (McGraw-Hill, New York, 1975).
I. M. Daniel, T. M. Wang, and J. T. Gotro, Winter Annual Meeting, Am. Soc. Mechanical Eng., San Francisco, CA (1989).
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Rao, P.S., Robertson, I.M. & Birnbaum, H.K. Effects of thermal cycling in a reducing atmosphere on metal/polyimide interfaces. Journal of Materials Research 9, 504–514 (1994). https://doi.org/10.1557/JMR.1994.0504
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1557/JMR.1994.0504