Abstract
The nucleation and morphology of diamond crystals and films synthesized by the use of a combustion flame have been investigated. By operating an oxy-acetylene torch in a fuel-rich mode, diamond crystals and films have been deposited on mechanically abraded molybdenum, on in situ created molybdenum carbide, and on thin diamond-like carbon (DLC) layers synthesized on molybdenum. Scanning electron microscopy, Auger and Raman spectroscopy have been used to characterize the films and crystals. Diamond is found to be uniformly deposited in the region of the substrate that intersects the inner, acetylene-rich region of the flame. The nucleation density, the growth rate, and the morphology of the diamond crystals and films are found to be strongly influenced by the surface condition of the substrate. On mechanically abraded molybdenum, abraded with 600 mesh silicon carbide, and on molybdenum carbide, well-formed cubo-octahedrons of diamond, up to 45 µm in diameter, are formed for deposition times of 90 min. Film formation is seldom observed under these conditions. To enhance nucleation, thin layers of DLC were formed on molybdenum substrates by reducing the O2/C2H2 ratio in the gas mix to ~ 0.75 for short periods of time under 30 s. This was followed by increasing the O2/C2H2 ratio to conditions that produce diamond (an O2/C2H2 ratio of ~ 0.9). Under these conditions the nucleation density of diamond was increased by an order of magnitude and the growth rates by about 60%, as compared to diamond deposited on abraded molybdenum and molybdenum carbide. In addition, the morphology of the diamond crystals and films was substantially affected with indications of dendritic growth. The DLC layer is effective in promoting diamond nucleation due to the high surface defect density and the high hydrogen concentration of these films. The combination of surface defects, in the form of dangling bonds, and the evolution of hydrogen from the DLC layer during the diamond deposition process, which is characterized by higher temperatures, result in a high concentration of active surface sites for diamond nucleation. The nucleation density, the distribution on the substrate, and the morphology of diamond crystals and films are not driven by the transport of reactive specie in the flame to the substrate, but rather by nucleation processes, temperature distribution across the surface, and attendant surface phenomena.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Proc. 1st Int. Symp. on Diamond and Diamond-Like Films, edited by J. P. Dismukes, K. E. Spear, B. S. Myerson, K.V. Ravi, T. D. Moustakas, and M. Yoder (The Electrochemical Society, Inc., Pennington, NJ, 1989).
Y. Hirose and N. Kondo, Program and Book of Abstracts, Japan Applied Physics 1988 Spring Meeting, 434 (1988).
Y. Hirose, S. Amanuma, N. Okada, and K. Komaki, Proc. 1st Int. Symp. on Diamond and Diamond-Like Films (The Electrochemical Society, Inc., Pennington, NJ, 1989), p. 80.
Y. Matsui, A. Yuuki, M. Sahara, and Y. Hirose, Jpn. J. Appl. Phys. 28, 1718 (1989).
L.M. Hanssen, W.A. Carrington, J.E. Butler, and K.A. Snail, Mater. Lett. 7, 289 (1988).
L.M. Hanssen, W.A. Carrington, D. Oakes, J.E. Butler, and K. A. Snail, Reprints of Papers Presented at the 197th ACS Meeting, Dallas, TX, April 9–14 (1989).
M. A. Cappelli and P. H. Paul, J. Appl. Phys. 67, 2596 (1990).
L.S. Piano and K.V. Ravi, SPIE Proceedings on Raman Scattering, Luminescence, and Spectroscopic Instrumentation in Technology 1055 (1989).
L.S. Piano, S. Yokota, and K.V. Ravi, Proc. 1st Int. Symp. Diamond and Diamond-Like Films (The Electrochemical Society, Inc., Pennington, NJ, 1989), p. 380.
N. Fujimori, T. Imai, and A. Doi, Vacuum 36, 99 (1986).
K.V. Ravi, M. Peters, L. Piano, and M. Pinneo, paper T21 presented at the SDIO/IST Diamond Technology Initiative Symposium, Crystal City, Arlington, VA (1988).
K.V Ravi, L. S. Piano, M. Pinneo, M. Peters, and S. Yokota, 1st Int. Conf. on the New Diamond Science and Technology-Tokyo, Program and Book of Abstracts, Paper 1.06 (1988).
D. E. Meyer, R. O. Dillon, and J. A. Wollman, J. Vac. Sci. Tech. A 7, 2325 (1989).
K. Kobashi, K. Nishimura, Y. Kawate, and T. Horiuchi, Phys. Rev. B 38, 4067 (1988).
A. Ono, H. Baba, H. Funamoto, and A. Nishikawa, Jpn. J. Appl. Phys. 25, L803 (1986).
G. S. Sandhu, M. L. Swanson, and W. K. Chu, paper presented at the Strategic Defence Initiative Organization/Innovative Science and Technology Diamond Technology Initiative Symposium, Crystal City, Arlington, VA (1989) (unpublished).
A. Joshi, R. Nimmagadda, and J. Herrington, J. Vac. Sci. Tech. A 8 (3), 2137 (1990).
Y. Hirose and Y. Terasawa, Jpn. J. Appl. Phys. 25, L591 (1986).
J. A. Mucha, D. L. Flamm, and D. E. Ibbotson, J. Appl. Phys. 65, 3448 (1989).
M.I. Landstrass and K.V. Ravi, Appl. Phys. Lett. 55, 975 (1989).
M.I. Landstrass and K.V. Ravi, Appl. Phys. Lett. 55, 1391 (1989).
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Ravi, K.V., Koch, C.A., Hu, H.S. et al. The nucleation and morphology of diamond crystals and films synthesized by the combustion flame technique. Journal of Materials Research 5, 2356–2366 (1990). https://doi.org/10.1557/JMR.1990.2356
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1557/JMR.1990.2356